Laboratoire Procédés et Ingénierie en Mécanique et Matériaux (PIMM): Recent submissions
Now showing items 1177-1183 of 1328
-
Article dans une revue avec comité de lecture;
GUSKOV, Mikhail (American Society of Mechanical Engineers, 2012)
Quasi-periodic motions and their stability are addressed from the point of view of different harmonic balance-based approaches. Two numerical methods are used: a generalized multidimensional version of harmonic balance and ... -
Communication avec acte(IAVSD, 2013)Currently, pantograph-catenary dynamic simulations codes are mainly based on deterministic approaches. However, the contact force between catenary and pantograph depends on many key parameters that are not always quantified ...
-
Article dans une revue avec comité de lecture(Elsevier, 2014)Indium oxide thin films were grown by pulsed electron beam deposition method at 500 °C on c-cut sapphire and (0 0 1) oriented LaAlO3 single crystal substrates in oxygen or argon gas. The effects of ambient gas and substrate ...
-
Article dans une revue avec comité de lecture; ; ; ;BRAHAM, Chedly (Elsevier, 2013)
The effects of hammering by wire brush as a method of improving low cycle fatigue life of highly ductile austenitic stainless steel AISI 304 have been investigated through an experimental study combining imposed strain ...
-
Article dans une revue avec comité de lecture; ; ; ; ; ; ; ; ;BRAHAM, Chedly (Elsevier, 2012)
Multi-reflection grazing incidence geometry, referred to as MGIXD, characterized by a small and constant incidence angle, was applied to measure low surface stresses in very thin layers of Al–Mg alloy and CrN coating. These ...
-
Article dans une revue avec comité de lecture; ;BRAHAM, Chedly (Elsevier, 2013)
This paper is aimed at evaluating the residual stress relaxation and its effect on the fatigue strength of AISI 316L steel ground surfaces in comparison to electro-polished surfaces. An experimental evaluation was performed ...
-
Article dans une revue avec comité de lecture; ;MECHBAL, Nazih; AOUSSAT, Améziane (American Society of Mechanical Engineers, 2013)
The aim of this paper is to present the design of a new long-range robotic arm based on an inflatable structure. Inflatable robotics has potential for improved large payload-to-weight ratios, safe collision, and inspection ...
