Input-Output Feedback Linearization for the Control of a 4 Cable-Driven Parallel Robot
Article dans une revue avec comité de lecture
Auteur
KUMAR, Atal AnilABBA, GabrielANTOINE, Jean-FrançoisRésumé
This paper presents the control of an under-constrained 4 Cable-Driven Parallel Robot (CDPR) using input-output feedback linearization technique. The dynamic model of the CDPR is first formulated by taking into account the Euler angle rates. Following this the input-output feedback linearization method is implemented to decouple the output and input. A linear feedback controller is then designed using pole placement method to control the CDPR. The control law is then verified by simulation using MATLAB software. Simple trajectories are then tested with and without the presence of noise to analyze the behavior of the control law.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Documents liés
Visualiser des documents liés par titre, auteur, créateur et sujet.
-
Article dans une revue avec comité de lecture(Elsevier BV, 2020)This paper presents the control of an underactuated four Cable-Driven Parallel Robot (CDPR) using a modified input-output feedback linearization technique. The effect of internal dynamics (due to the underactuated degrees ...
-
Article dans une revue avec comité de lecture(2004)This paper deals with the study of high speed switched reluctance motors and their pre-dimensioning. The predimensioning is tackled towards the inductance profile and the torque generation. Then, the power density is ...
-
Article dans une revue avec comité de lecture;
ASTOLFI, Jacques Andre; ; (Elsevier, 2009)
The present study is developed within the framework of marine structure design operating in transient regimes. It deals with an experimental and numerical investigation of the time–space distribution of the wall-pressure ... -
Article dans une revue avec comité de lecture; ; ; ;DANTAN, Jean-Yves (Elsevier, 2013)
Uncertainty in product characteristics is ubiquitous in any engineering system at all the stages of product life-cycle. Considering uncertainty from different sources during the product design phase is critical to its ...
-
Article dans une revue avec comité de lecture;DANTAN, Jean-Yves; PAILHES, Jerome; (Taylor & Francis, 2016)
The main objective in designing a product is to satisfy the required needs. So, the designer aims to design the product’s structure based on the required function of the product. Therefore, in the design process, the link ...