Flax Fibers Reinforced Thermoplastic Resin Based Biocomposites, a Future for Sustainable Composite Parts
Communication avec acte
Résumé
One of the major challenges of thermoplastic matrix based composites is to manufacture finished parts both in one shot process and in a reduced time production. For this purpose, two techniques were developed to manufacture eco-friendly composites: one is the stamping using hot and cold airflow and the second one concern a one shot manufacturing of sandwich using infusion process. Then, several quasi-static and dynamic analyses were performed to validate the efficiency of the developed processes and to confirm the good quality of the material.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Documents liés
Visualiser des documents liés par titre, auteur, créateur et sujet.
-
Article dans une revue avec comité de lectureThis article presents the mechanical characterization of an eco composite consisting of a thermoplastic matrix reinforced by flax fibres. Different configurations of specimens were tested with uniaxial tensile loading and ...
-
Article dans une revue avec comité de lectureThis paper presents the results of experimental and numerical analyses of the flexural vibration behaviour of bio-based sandwich structures and their composite faces, and particularly their damping properties. The material ...
-
Article dans une revue avec comité de lectureThis paper presents the results of several experimental analyses performed on a biobased sandwich structure. The material studied is made up of thermoplastic skins reinforced by flax fibres and applied to a balsa core. It ...
-
Conférence invitéeOne of the major challenges of composites based on a thermoplastic matrix is to fabricate finished parts both in a single processing step and reduced time production. For this purpose, a stamping airflow device is here ...
-
Conférence invitéeMechanical behavior of composite laminates depends strongly on the manufacturing process. It is necessary to use representative samples of the material, and therefore of the process. In the case of filament winding, specimens ...