Development of a quick-stop device for micro-cutting
Article dans une revue avec comité de lecture
Author
PIQUARD, RomainFONTAINE, MichaëlTHIBAUD, SébastienGILBIN, AlexandreLE COZ, Gaël 
D’ACUNTO, AlainAbstract
Micro-cutting is characterised by undeformed chip thicknesses in the micron range. This range leaves little choice of in situ observation techniques. One solution is therefore to observe these zones a posteriori after the cutting has been abruptly interrupted. This technique has proven to be very useful for conventional machining. This paper deals with the development of a quick-stop device dedicated to micro-cutting. The aim of this device is to observe cutting mechanisms and chip formation at this scale in order to enhance micro-cutting models.
Files in this item
Related items
Showing items related by title, author, creator and subject.
-
Study of the Influence of Cutting Edge on Micro Cutting of Hardened Steel Using FE and SPH Modeling Article dans une revue avec comité de lecture; ; ; ; ; ; ; ;D’ACUNTO, Alain (MDPI, 2022-07)
Micromachining allows the production of micro-components with complex geometries in various materials. However, it presents several scientific issues due to scale reduction compared to conventional machining. These issues ...
-
Communication avec acte; ;D’ACUNTO, Alain; ; ; (Institut Français de Mécanique Avancée, 2014)
Cet article présente des essais de micro-coupe orthogonale et oblique à partir de tournage sur un acier 40NiCrMo16. Les résultats obtenus démontrent l’influence du rayon d’acuité d’arête sur les efforts mesurés notamment ...
-
Communication avec acte; ; ;D’ACUNTO, Alain; ; (Czech Machine Tool Society, 2014)
In order to model micro-milling cutting forces, a way is to apply a local model on discretized elements of the cutting edge and then summing on the whole edge to obtain the global cutting forces. This local model is usually ...
-
Article dans une revue avec comité de lecture; ; ; ;D’ACUNTO, Alain (Elsevier BV, 2022)
The success of biomedical implantation is linked to osseointegration, depending on the mechanical loading of the bone interface. The large difference in stiffness between the host bone (30 GPa) and the usual implant ...
-
Communication avec acte;D’ACUNTO, Alain; (Czech Machine Tool Society, 2014)
Micro-milling can be defined as milling with end mills smaller than 1 mm of diameter. The top-down approach from milling to micro-milling is often used to define cutting conditions. Unfortunately geometries either for the ...