• français
    • English
    English
  • Ouvrir une session
Aide
Voir le document 
  •   Accueil de SAM
  • Laboratoire d'Electrotechnique et d'Electronique de Puissance (L2EP) de Lille
  • Voir le document
  • Accueil de SAM
  • Laboratoire d'Electrotechnique et d'Electronique de Puissance (L2EP) de Lille
  • Voir le document
JavaScript is disabled for your browser. Some features of this site may not work without it.

Energy Management Strategy for Commercial Buildings Integrating PV and Storage Systems

Communication avec acte
Auteur
ZANG, He
13338 Laboratoire d’Électrotechnique et d’Électronique de Puissance - ULR 2697 [L2EP]
DAVIGNY, Arnaud
13338 Laboratoire d’Électrotechnique et d’Électronique de Puissance - ULR 2697 [L2EP]
SPROOTEN, Jonathan
13338 Laboratoire d’Électrotechnique et d’Électronique de Puissance - ULR 2697 [L2EP]
ROBYNS, Benoit
13338 Laboratoire d’Électrotechnique et d’Électronique de Puissance - ULR 2697 [L2EP]
COLAS, Frédéric
13338 Laboratoire d’Électrotechnique et d’Électronique de Puissance - ULR 2697 [L2EP]
POSTE, Yvan
13338 Laboratoire d’Électrotechnique et d’Électronique de Puissance - ULR 2697 [L2EP]

URI
http://hdl.handle.net/10985/6414
DOI
10.1007/978-3-642-27509-8_14
Date
2012

Résumé

This paper presents an energy management strategy for a commercial building in supermarket application. Some objectives are established as load shedding, to reduce the electricity bill and the CO2 emissions of commercial building, such as supermarkets, in using PV and storage systems. An energy management supervision strategy based on the rules of the electricity bill will be presented. This paper focuses on the supervision strategy with the help of fuzzy logic. It is shown, with the help of simulations and comparisons, that the energy bill cost and the CO2 emissions can be reduced by using the solution proposed.

Fichier(s) constituant cette publication

Nom:
SEB2011_spinger_shorter.pdf
Taille:
747.6Ko
Format:
PDF
Voir/Ouvrir

Cette publication figure dans le(s) laboratoire(s) suivant(s)

  • Laboratoire d'Electrotechnique et d'Electronique de Puissance (L2EP) de Lille

Documents liés

Visualiser des documents liés par titre, auteur, créateur et sujet.

  • Distributed Economic Dispatch of Embedded Generation in Smart Grids 
    Article dans une revue avec comité de lecture
    DIBANGOYE, Jille; GUILLAUD, Xavier; COLAS, Frédéric; FAKHAM, Hicham; DONIEC, Arnaud (Elsevier, 2015)
    In a Smart Grid context, the increasing penetration of embedded generation units leads to a greater complexity in the management of production units. In this arti- cle, we focus on the impact of the introduction of ...
  • Numerical study of a sinusoidal transverse propeller 
    Communication avec acte
    FASSE, Guillaume; ccBAYEUL-LAINÉ, Annie-Claude; ccCOUTIER-DELGOSHA, Olivier; CURUTCHET, Arnaud; PAILLARD, Benoît; ccHAUVILLE, Frederic (2018)
    In order to obtain higher propulsion efficiency for marine transportation, the authors have numerically tested a novel trochoidal propeller using a sinusoidal blade pitch function. The main results presented here are the ...
  • Measurement of lattice rotations and internal stresses in over one hundred individual grains during a stress-induced martensitic transformation 
    Conférence invitée
    EL HACHI, Younes; MALARD, Benoît; WRIGHT, Jonathan; ccBERVEILLER, Sophie (EDP Sciences, 2015)
    To better understand the properties of polycrystals at a microscopic scale during cyclic mechanical loading we have measured the relationship between grain orientations, their positions inside the sample and their internal ...
  • In situ synchrotron analysis of lattice rotations in individual grains during stress-induced martensitic transformations in a polycrystalline CuAlBe shape memory alloy 
    Article dans une revue avec comité de lecture
    MALARD, Benoît; WRIGHT, Jonathan; PATOOR, Etienne; GEANDIER, Guillaume; ccBERVEILLER, Sophie (Elsevier, 2011)
    Two synchrotron diffraction techniques, three-dimensional X-ray diffraction and Laue microdiffraction, are applied to studying the deformation behaviour of individual grains embedded in a Cu74Al23Be3 superelastic shape ...
  • Using relative head and hand-target features to predict intention in 3D moving-target selection 
    Communication avec acte
    CASALLAS, Juan Sebastian; OLIVER, James H.; KELLY, Jonathan W.; ccMERIENNE, Frédéric; ccGARBAYA, Samir (IEEE, 2014)
    Selection of moving targets is a common, yet complex task in human-computer interaction (HCI) and virtual reality (VR). Predicting user intention may be beneficial to address the challenges inherent in interaction techniques ...

Parcourir

Tout SAMLaboratoiresAuteursDates de publicationCampus/InstitutsCe LaboratoireAuteursDates de publicationCampus/Instituts

Lettre Diffuser la Science

Dernière lettreVoir plus

Statistiques de consultation

Publications les plus consultéesStatistiques par paysAuteurs les plus consultés

ÉCOLE NATIONALE SUPERIEURE D'ARTS ET METIERS

  • Contact
  • Mentions légales

ÉCOLE NATIONALE SUPERIEURE D'ARTS ET METIERS

  • Contact
  • Mentions légales