High pressure water jet assisted machining of duplex steel: machinability and tool life
Article dans une revue avec comité de lecture
Auteur
BRAHAM-BOUCHNAK, TarekROBERT, PatrickLEBRUN, Jean-LouAUGER, Stéphane 
GERMAIN, GuénaëlRésumé
High pressure water jet assisted turning (HPWJAT) consists of projecting a high pressure water jet, up to several hundred bar, into the tool-workpiece interface. The water jet is directed between the chip and the tool affording greater protection of the cutting face and better chip breaking. Comparisons are made between assisted turning using several jet pressures and conventional turning with different cutting speeds on the duplex stainless steel, X2CrNiMo22-5. The results show good chip fragmentation and an improvement of tool life with high pressure water jet assistance (HPWJAT). The evolution of the roughness is also investigated. It is shown that it is possible to improve the productivity by using HPWJAT.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Documents liés
Visualiser des documents liés par titre, auteur, créateur et sujet.
-
Article dans une revue avec comité de lecture; ; ; ;GERMAIN, Guénaël (SpringerLink, 2008)
Laser assisted machining (LAM) can improve the machinability of materials by locally heating the material prior to its removal. The work presented here is a study of the laser assisted machining of Inconel 718 (NiCr19FeNb ...
-
Article dans une revue avec comité de lecture; ; ;GERMAIN, Guénaël (Springer Verlag, 2013)
The Ti533-3 alloy is a new titanium alloy which is starting to see increased use in the aeronautical domain to improve the durability of components and to optimize the weight/resistance ratio. This alloy is characterized ...
-
Article dans une revue avec comité de lecture; ; ; ;GERMAIN, Guénaël (2005)
This study shows experimental and numerical preliminary approaches of laser assisted machining. The laboratory has an industrial lathe equipped with a laser source with 2.5 kW to carry out experiments on various materials. ...
-
Article dans une revue avec comité de lectureGERMAIN, Guenael; ; (American Society of Mechanical Engineers, 2013)
Determining a material constitutive law that is representative of the extreme conditions found in the cutting zone during machining operations is a very challenging problem. In this study, dynamic shear tests, which ...
-
Article dans une revue avec comité de lecture;GERMAIN, Guénaël; ; (Taylor & Francis, 2015)
The origin of this article is the quantification of productivity gains and the improvement in surface integrity seen for a recent titanium alloy that is seeing increasing use in the aeronautical industry. The Ti555–3 ...