Evaluation of the performance of coated and uncoated carbide tools in drilling thick CFRP/aluminium alloy stacks
Article dans une revue avec comité de lecture
This paper aims to establish the wear mechanisms of coated and uncoated tungsten carbide drills when drilling carbon fibre reinforced plastics (CFRP)/aluminium alloy (Al) stacks. During the drilling experiments, thrust forces were measured. A scanning electron microscope (SEM) and a numerical microscope, provided with a scanning device, were periodically used to analyse tool wear mechanisms and to measure wear progression of the tool cutting edges. For both coated and uncoated drills, abrasion was the dominant tool wear mechanism, affecting the entire cutting edges. Higher wear was observed on uncoated tools which caused a significant increase in thrust force during drilling both Al and CFRP materials. The influence of these phenomena on the quality of the holes and on the generated roughness was also discussed.
Files in this item
Showing items related by title, author, creator and subject.
Article dans une revue avec comité de lectureMONTOYA, Maxime; CALAMAZ, Madalina; GEHIN, Daniel; GIROT, Franck (Trans Tech Publications, 2014)Temperature reached at the tool/workpiece interface is difficult to measure during drilling operation, due to its enclosed configuration; numerical simulation is therefore a good alternative to access to this information. ...
Cutting Forces Parametric Model for the Dry High Speed Contour Milling of Aerospace Aluminium Alloys Article dans une revue avec comité de lectureSALGUERO, Jorge; BATISTA, Moises; CALAMAZ, Madalina; GIROT, Franck; MARCOS, Mariano (Elsevier, 2013)Cutting forces is one of the most important outputs in material removal machining processes. Their values depend on a large number of parameters, such as the cutting tool material and geometry, the workpiece material or ...
Toward a better understanding of tool wear effect through a comparison between experiments and SPH numerical modelling of machining hard materials Article dans une revue avec comité de lectureCALAMAZ, Madalina; LIMIDO, Jérôme; NOUARI, Mohammed; ESPINOSA, Christine; COUPARD, Dominique; SALAUN, Michel; GIROT, Franck; CHIERAGATTI, Rémy (Elsevier, 2009)The aim of this study is to improve the general understanding of tungsten carbide (WC–Co) tool wear under dry machining of the hard-to-cut titanium alloy Ti6Al4V. The chosen approach includes experimental and numerical ...
Mécanismes d'usure des outils coupants en usinage à sec de l'alliage de titane aéronautique Ti–6Al–4V Article dans une revue avec comité de lectureNOUARI, Mohammed; CALAMAZ, Madalina; GIROT, Franck (Elsevier Masson, 2008)In the present study, the titanium alloy ‘Ti–6Al–4V’ is orthogonally machined without cutting fluid. During experiments, the cemented carbide tools were rigidly mounted on the tool holder with rake angles of 0°, 15° and ...
A new material model for 2D numerical simulation of serrated chip formation when machining titanium alloy Ti-6Al-4V Article dans une revue avec comité de lectureCALAMAZ, Madalina; COUPARD, Dominique; GIROT, Franck (Elsevier, 2008)A new material constitutive law is implemented in a 2D finite element model to analyse the chip formation and shear localisation when machining titanium alloys. The numerical simulations use a commercial finite element ...