Residual Stresses Induced by Dry and Cryogenic Cooling during Machining of AZ31B Magnesium Alloy
Article dans une revue avec comité de lecture
Résumé
The major challenge of the Mg alloys has been their unsatisfactory corrosion resistance, which can be enhanced by improving the surface integrity. Cryogenic machining, where liquid nitrogen was used during machining, has been reported to improve the surface integrity of machined components, including compressive residual stresses. This paper analyses the influence of several cutting parameters, tool geometry and cryogenic conditions on the surface and subsurface residual stresses distribution.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Documents liés
Visualiser des documents liés par titre, auteur, créateur et sujet.
-
Communication avec acteBATISTA, Antonio; ROSSI, Frederic; FROMENTIN, Guillaume; GERMAIN, Guénaël; POULACHON, Gerard; MARTINS DO OUTEIRO, Jose Carlos (Elsevier, 2013)The corrosion resistance of magnesium alloys depends mainly on its surface integrity. Previous experimental studies have shown that machining can induces small (nano-scale) grain size, compressive residual stresses and ...
-
Article dans une revue avec comité de lectureNOBRE, Joao Paulo; STIFFEL, J.-H.; NAU, A.; BATISTA, Antonio; VAN PAEPEGEM, W.; SCHOLTES, B.; MARTINS DO OUTEIRO, Jose Carlos (Elsevier, 2013)Residual strains induced by drilling of glass-fibre reinforced polymers (GFRP) were determined using a hybrid experimental-numerical methodology. Experimentally, a set of GFRP specimens were drilled under well-defined ...
-
Communication avec acteCARUSO, Serafino; UMBRELLO, Domenico; BATISTA, Antonio; MARTINS DO OUTEIRO, Jose Carlos (Trans Tech Publications, 2014)Residual stress is one of the most important surface integrity parameter that can significantly affect the service performance of a mechanical component, such as: contact fatigue, corrosion resistance and part distortion. ...
-
Article dans une revue avec comité de lectureCARERI, Francesco; IMBROGNO, Stano; UMBRELLO, Domenico; ATTALLAH, Moataz M.; MARTINS DO OUTEIRO, Jose Carlos; BATISTA, António C. (Elsevier, 2021)The aim of this study is to determine the most suitable post-processing routines to enhance the surface integrity of components produced with Inconel 718 superalloy by additive manufacturing. The components were fabricated ...
-
Communication avec acteM'SAOUBI, Rachid; CHANDRASEKARAN, H.; COULON, Bertrand; MARQUES, M.J.; MARTINS DO OUTEIRO, Jose Carlos (2008)Machinability enhancement of hot work tool steels can be achieved intrinsically through tailoring of alloying elements and steel processing route but also externally through the use of adequate tooling. The aim of the ...