Understanding friction induced damping in bolted assemblies through explicit transient simulation
Communication avec acte
The design of joints is seeing increased interest as one of the ways of controlling damping levels in lighter and more ﬂexible aeronautic structures. Damping induced by joint dissipation has been studied for more than a decade, mostly experimentally due to the difﬁculty of simulating large structures with non-linearities. Experimentally ﬁtted meta-models were thus used for damping estimation at design stage without a possible optimization. The aim of this paper is to demonstrate that damping estimation using local friction models is feasible and that it can be usable for design. The simulation methodology is based on an explicit Newmark time scheme with model reduction and numerical damping that can be compensated for the modes of interest. Practical simulation times counted in minutes are achieved for detailed models. The illustration on a lap-joint shows how simulations can be used to predict the amplitude dependence of modal damping, answer long standing questions such as “does the modeshape change?” or analyze the evolution of pressure ﬁelds during a cycle.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Visualiser des documents liés par titre, auteur, créateur et sujet.
Communication avec acteMARTIN, Guillaume; BALMES, Etienne; VERMOT DES ROCHES, Guillaume; CHANCELIER, Thierry (2015)To be confident in the prediction capability of a model, verification and validation steps are classically performed. Verification checks that the model is properly solved. Since the model used are fairly standard, this ...
Squeal measurement with 3D Scanning Laser Doppler Vibrometer: handling of the time varying system behavior and analysis improvement using FEM expansion Communication avec acteMARTIN, Guillaume; CHANCELIER, Thierry; VERMOT DES ROCHES, Guillaume; BALMES, Etienne (2018)In the presence of squeal, Operational Deflection Shapes (ODS) are classically performed to analyze behavior. A simple numeric example is used to show that two real shapes should dominate the response. This justifies an ...
Communication avec acteMARTIN, Guillaume; BALMES, Etienne; VERMOT DES ROCHES, Guillaume; CHANCELIER, Thierry (2016)Squeal occurrences are quite common in brakes in production and involve coupling of modes. Detailed understanding of vibration patterns typically requires FEM models updated using test results. The process used at Chassis ...
Squeal measurement using operational deflection shape. Quality assessment and analysis improvement using FEM expansion. Communication avec acteBALMES, Etienne; VERMOT DES ROCHES, Guillaume; CHANCELIER, Thierry; MARTIN, Guillaume (FISITA, 2017)In presence of squeal, Operational Deflection Shapes (ODS) are classically measured to gain understanding of brake behavior. A simple numeric example is analyzed to justify the use of time-frequency analysis and shows that ...
Communication avec acteMARTIN, Guillaume; VERMOT DES ROCHES, Guillaume; BALMES, Etienne; CHANCELIER, Thierry (2019)In brake FEM, model updating is often needed to improve the model accuracy and well describe problematic phenomena such as the squeal. To avoid performing a full model updating which is often time consuming, the use of the ...