Time to failure prediction in rubber components subjected to thermal ageing: A combined approach based upon the intrinsic defect concept and the fracture mechanics
TypeArticles dans des revues avec comité de lecture
In this contribution, we attempt to derive a tool allowing the prediction of the stretch ratioat failure in rubber components subjected to thermal ageing. To achieve this goal, the mainidea is to combine the fracture mechanics approach and the intrinsic defect concept. Using an accelerated ageing procedure for an Ethylene–Propylene–Diene Monomer (EPDM), it is first shown that the average molar mass of the elastically active chains (i.e. between crosslinks) can be used as the main indicator of the macromolecular network degradation. Byintroducing the time–temperature equivalence principle, a shift factor obeying to an Arrhenius law is derived, and master curves are built as well for the average molar mass as for the ultimate mechanical properties. Fracture mechanics tests are also achieved and the square root dependence of the fracture energy with the average molar mass is pointed out. Moreover, it is shown that the mechanical response could be approximated by the phantom network theory, which allows to relate the strain energy density function to the average molar mass. Assuming that the fracture of a smooth specimen is the consequence of a virtual intrinsic defect whose the size can be easily estimated, the stretch ratio at break can be therefore computed for any thermal ageing condition. The estimated values are found in a very nice agreement with EPDM experimental data, making this approach a useful tool when designing rubber components for moderate to high temperature environments.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Visualiser des documents liés par titre, auteur, créateur et sujet.
NAÏT-ABDELAZIZ, Moussa; AYOUB, Georges; COLIN, Xavier; BENHASSINE, M.; MOUWAKEH, M. (Elsevier, 2019)In this work, the influence of thermal oxidative aging on the ultimate mechanical properties of rubbers is investigated. Two new approaches to predict failure properties are proposed. The first one is the stress limiter ...
SHABAN, Amin; COLIN, Xavier; MARQUE, Gregory; MONCHY-LEROY, Carole (Rubber Division of the American Chemical Society, 2014)The considerable amount of research in the literature has practically allowed the elucidation of the mechanism of peroxide cross-linking of ethylene–propylene–diene–monomer rubber (EPDM), which occurs through a radical ...
Chain branching detection by Cole–Cole modeling of rheological properties changes during PET mechanical recycling NAIT-ALI, K.L.; BERGERET, A; FERRY, L; COLIN, Xavier (ELSEVIER, 2012)The detection of branched chains in thermally degraded thermoplastic polymers is far from simple, especially at a low conversion ratio, mainly because of the low sensitivity of commonly used laboratory analytical techniques. ...
EL MAZRY, Chaker; BEN HASSINE, Mouna; CORREC, Olivier; COLIN, Xavier (ELSEVIER, 2013)Thermal aging of an additive free PA 6-6 has been elucidated at 90, 100, 120, 140, 150 and 160 C in airventiled ovens by Fourier transform infrared spectrophotometry, viscosimetry in molten state and uniaxial tensile ...
LACUVE, Maxime; COLIN, Xavier; PERRIN, Lara; NOTINGHER, Petru; TOURCHER, Christophe; BEN-HASSINE, Mouna; TANZEGHTI, Houssam (2019)The water sorption properties (i.e. diffusivity and solubility) of three unfilled vulcanized EPDMs were investigated in wet atmosphere (typically between 0 and 95% RH) and in pure distilled water (denoted as 100% RH) at ...