Tool-life and wear mechanisms of CBN tools in machining of Inconel 718
Article dans une revue avec comité de lecture
Date
2007Journal
International Journal of Machine Tools and ManufactureRésumé
The demand for increasing productivity when machining heat resistant alloys has resulted in the use of new tool materials such as cubic boron nitride (CBN) or ceramics. However, CBN tools are mostly used by the automotive industry in hard turning, and the wear of those tools is not sufficiently known in aerospace materials. In addition, the grade of these tools is not optimized for superalloys due to these being a small part of the market, although expanding (at 20% a year). So this investigation has been conducted to show which grade is optimal and what the wear mechanisms are during finishing operations of Inconel 718. It is shown that a low CBN content with a ceramic binder and small grains gives the best results. The wear mechanisms on the rake and flank faces were investigated. Through SEM observations and chemical analysis of the tested inserts, it is shown that the dominant wear mechanisms are adhesion and diffusion due to chemical affinity between elements from workpiece and insert.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Documents liés
Visualiser des documents liés par titre, auteur, créateur et sujet.
-
Communication sans acteSELMI, Jaouher; COSTES, Jean-Philippe; CARRAS, Patrice; LORONG, Philippe; POULACHON, Gerard (Congrès Français de Mécanique, 2013)Machine tool is the most used manufacturing means in automotive industry. This kind of manufacturing machine is very expensive and has immediate influence on produced workpiece quality. During machining process design, a ...
-
Communication avec acteSELMI, Jaouher; COSTES, Jean-Philippe; CARRAS, Patrice; LORONG, Philippe; POULACHON, Gerard (MM Science Journal, 2014)It is proposed to apply a methodology in order to evaluate the ability of different machining systems (Spindle/Tool) to run a reaming process in a stable way.The methodology is based on an experimental measurement of the ...
-
Communication avec acteUne méthodologie est proposée dans cet article dans le but de faciliter l’évaluation de la stabilité d’une opération de fraisage, pour une broche, un outil et une position connue de la broche dans son espace de travail. ...
-
Article dans une revue avec comité de lectureSELMI, Jaouher; COSTES, Jean-Philippe; CARRAS, Patrice; LORONG, Philippe; POULACHON, Gerard (Springer Verlag, 2016)This article presents an original study about the dynamic of a machining operation based on the coupling receptance methodology. The Frequency Response Function (FRF) of a machine tool is numerically coupled with the FRF ...
-
Article dans une revue avec comité de lectureSELMI, Jaouher; COSTES, Jean-Philippe; CARRAS, Patrice; LORONG, Philippe; POULACHON, Gerard (Springer Verlag, 2016)This article presents an original study about the dynamic of a machining operation based on the coupling receptance methodology. The Frequency Response Function (FRF) of a machine tool is numerically coupled with the FRF ...