SAM: Soumissions récentes
Voici les éléments 3115-3121 de 6547
-
Article dans une revue avec comité de lecture; ; ;
GUILLAUMAT, Laurent (SAGE Publications, 2018)
This paper presents the results of several experimental analyses performed on a biobased sandwich structure. The material studied is made up of thermoplastic skins reinforced by flax fibres and applied to a balsa core. It ... -
Article dans une revue avec comité de lecture; ; ;MERAGHNI, Fodil; ; ; (Springer Verlag, 2019)
The consequences of a four-point bending test, up to 12 mm, are examined by emitting 1 MHz ultrasonic guided waves in woven carbon fiber reinforced polymer specimens, using coda wave interferometry (CWI), revealing a ...
-
Communication sans acte;SEMAIL, Eric; NGUYEN, Ngac Ky (CNRS, 2019)
This paper proposes a sensorless control based on Sliding Mode Observer (SMO) for a Five-phase Interior Permanent Magnet Synchronous Machine (FIPMSM), with a consideration of the third harmonic component. Compared to the ...
-
Communication avec acte(2019)Rubber mounts are elements of extreme importance in automotive suspension, and accurate modeling is crucial for comfort design. While mount characterization is typically done using cycles, actual performance is often ...
-
Characterization of intergranular stress corrosion cracking behavior of a FSW Al-Cu-Li 2050 nugget Article dans une revue avec comité de lecture; ;SAINTIER, Nicolas; (EDP Sciences, 2015)
This study deals with the in service durability of an alloy Al-Cu-Li 2050 friction stir welded. In an aeronautical context, this material could be submitted to mechanical stresses and a corrosive environment. Thus, the aim ...
-
Article dans une revue avec comité de lecture; ; ; ;KOPP, Jean-Benoit (Elsevier, 2019)
The aim of this study is to evaluate the effect of the loading rate on the mechanical properties and damage mechanisms of a Glass/Elium150 laminate composite. Quasi-static indentation (QS) and low energy dynamic impact ...
-
Article dans une revue avec comité de lecture;EL MANSORI, Mohamed (Springer Verlag, 2016)
In manufacturing sectors, machining hybrid CFRP/Ti is usually an extremely challenging task due to the disparate natures of each stacked constituent involved and their respectively poor machinability. The current research ...
