SAM: Soumissions récentes
Voici les éléments 3836-3842 de 6449
-
Article dans une revue avec comité de lecture; ; ; ; ;
MONTAGNE, Alex (Maney Publishing, 2017)
Cr–Zr–N films have been synthesised using R.F reactive magnetron sputtering system on Si (100) wafer and XC100 steel substrate without heating. The structural, mechanical and friction coefficient evolution as a function ... -
Article dans une revue avec comité de lecture; ; ;MONTAGNE, Alex (Trans Tech Publications, 2017)
The aim of this research paper is to fabricate a Fe-TiC composite by a novel and simple manufacturing method. The latter is based on two cumulative processes; a conventional sintering (transient liquid phase sintering) and ...
-
Article dans une revue avec comité de lecture;FAVIER, Véronique; ; ; ; (ESIS - Elsevier, 2016)
The aim of the present research was to study the self-heating behavior of a dual-phase steel under ultrasonic fatigue loading for stress amplitudes lower than the conventional fatigue limit. The steel studied in this ...
-
Article dans une revue avec comité de lecture; ; ; ;MONTAGNE, Alex (Elsevier, 2016)
The aim of this work is to assess the mechanical properties of the different layers composing a CIGS based solar cell. Fabrication uses the magnetron sputtering deposition technique (except for the CdS layer which was ...
-
Chapitre d'ouvrage scientifique; ;MALBURET, François (Springer International Publishing, 2017)
n the last 20 years, computer science has considerably progressed and there has been a resurgence of interest in bond graphs. The evolution of bond graph software has allowed for the full exploitation of its graphical ...
-
Article dans une revue avec comité de lectureMAREAU, Charles; (Elsevier, 2017)
FFT-based homogenization methods aim at calculating the effective behavior of heterogeneous materials with periodic microstructures. These methods operate on a regular grid of voxels, and hence require an appropriate spatial ...
-
Article dans une revue avec comité de lecture(Elsevier, 2017)In this paper, the feasibility of using a fiber laser to perform a dissimilar metal joining was explored. AZ31B magnesium and 316 stainless steel were autogenously joined in butt configuration. The weldability between ...
