SAM: Soumissions récentes

Voici les éléments 5288-5294 de 6380

    • Effect of the sand-blasting of edge peeling tools on the cutting forces and wear resistance 
      Communication avec acte
      LABIDI, Chafik; HENRY, Laurent; NOUVEAU, Corinne; DENAUD, Louis; ccCOLLET, Robert (Presses Polytechniques et Universitaires Romandes, 2007)
      One of the major problems concerning tools of wood industry is nicks occurrence on the cutting edge. This phenomenon is accentuated by the small tool angle of most of the wood machining tools. The aim of this present study ...
    • DEMARCHE DE CONCEPTION D’UN ESSAI DE CARACTERISATION MECANIQUE MULTI-INSTRUMENTE : CAS D'UN TEST DE MISE SOUS PRESSION D’ANNEAU COMPOSITE 
      Communication sans acte
      PILATO, Aurélie; BOIS, Christophe; WAHL, Jean-Christophe; ccPERRY, Nicolas (2012)
      le stockage de l'hydrogène sous forme gazeuse nécessite de développer les modèles de comportement des réservoirs composites (carbone époxy) réalisés en utilisant le procédé d'enroulement filamentaire. Ces réservoirs ...
    • Influence of a pulsed laser regime on surface finish induced by thedirect metal deposition process on a Ti64 alloy 
      Article dans une revue avec comité de lecture
      GHARBI, Myriam; PEYRE, Patrice; GORNY, Cyril; MORVILLE, Simon; LE MASSON, Philippe; CARRON, Denis; FABBRO, Rémy; CARIN, Muriel (Elsevier, 2014)
      tThe direct metal deposition (DMD) laser technique is a free-form metal deposition process, which allowsgenerating a prototype or small series of near net-shape structures. Despite numerous advantages, oneof the most ...
    • Very high cycle fatigue of copper: Evolution, morphology and locations of surface slip markings 
      Article dans une revue avec comité de lecture
      PHUNG, Ngoc-Lam; VALES, Fréderic; MURGHRABI, Haël; ccRANC, Nicolas; ccFAVIER, Véronique (Elsevier, 2014)
      The surfaces of commercially pure polycrystalline copper specimens subjected to interrupted 20 kHz fatigue tests in the very high cycle fatigue regime were investigated. The stress amplitude needed to form the early slip ...
    • Cable length optimization for trawl fuel consumption reduction 
      Article dans une revue avec comité de lecture
      KHALED, Ramez; PRIOUR, Daniel; BILLARD, Jean-Yves (Elsevier, 2013)
      A numerical method for optimization of the cable lengths in trawls with respect to the ratio between the estimated trawl drag and the predicted catch efficiency is developed and applied. The trawl cables of interest are ...
    • Feedrate planning for machining with industrial six-axis robots 
      Article dans une revue avec comité de lecture
      DAMAK, Mohamed; ccOLABI, Adel; ccBEAREE, Richard; ccGIBARU, Olivier (Elsevier, 2010)
      Nowadays, the adaptation of industrial robots to carry out high-speed machining operations is strongly required by the manufacturing industry. This new technology machining process demands the improvement of the overall ...
    • Limits of Kansei – Kansei unlimited 
      Article dans une revue avec comité de lecture
      BONGARD-BLANCHY, Kerstin; BOUCHARD, Carole; ccAOUSSAT, Améziane (2013)
      This article discusses momentary limitations of the Kansei Engineering methods. There are for example the focus on the evaluation of colour and form factors, as well as the highly time consuming creation of the questionnaires. ...