SAM: Recent submissions
Now showing items 1620-1626 of 6547
-
Article dans une revue avec comité de lecture; ; ;
NOUVEAU, Corinne (Elsevier BV, 2021)
Ti-Cr-N coatings were deposited on Si (100) and AISI D2 tool steel substrates by reactive DC magnetron co- sputtering technique from titanium and chromium target in mixed Ar/N2 atmosphere. The Ar/N2 ... -
Article dans une revue avec comité de lecture; ; ; ; ;DERRIEN, Katell (Elsevier BV, 2021)
The aim of this paper is to investigate the effective properties of Fe–TiB2 composites obtained after hot or cold rolling. The elastic moduli of both hot and cold rolled composites are measured experimentally using several ...
-
Article dans une revue avec comité de lecture; ;MERAGHNI, Fodil (Elsevier BV, 2021)
A new hybrid homogenization approach is proposed for simulating the homogenized and local response of unidirectional fuzzy fiber nanocomposites undergoing inelastic deformations. Fuzzy fiber composites are hierarchical ...
-
Article dans une revue avec comité de lecture(MDPI AG, 2021)Through the years, laser shock peening became a treatment of choice in the aerospace industry to prolong the life of certain critical pieces. Water flow is commonly used as a confinement to improve the process capability ...
-
Article dans une revue avec comité de lecture;SEMAIL, Eric; NGUYEN, Ngac Ky (Lavoisier, 2021)
This paper proposes a sensorless control strategy based on Sliding Mode Observer (SMO) for a Five-phase Interior Permanent Magnet Synchronous Machine (FIPMSM), with a consideration of the third harmonic component. Compared ...
-
Communication avec acte;CHALAL, Hocine; ABED-MERAIM, Farid (2016)
Plastic instabilities such as diffuse or localized necking may occur during sheet metal forming processes, thus limiting sheet metal formability, which is detrimental to industry. The formability of sheet metals is usually ...
-
Article dans une revue avec comité de lecture; ;PERRY, Nicolas; MONTEMURRO, Marco (Wiley, 2021)
An efficient and general surface reconstruction strategy is presented in this study. The proposed approach can deal with both open and closed surfaces of genus greater than or equal to zero and it is able to approximate ...
