SAM: Recent submissions

Now showing items 3526-3532 of 6547

    • Impact of control algorithm solutions on Modular Multilevel Converters electrical waveforms and losses 
      Communication avec acte
      FREYTES, Julian; SAMIMI, Shabab; DELARUE, Philippe; GUILLAUD, Xavier; COLAS, Frédéric; BELHAOUANE, Mohamed Moez (IEEE, 2015)
      Modular Multilevel Converters (MMC) are becoming increasingly popular with the development of HVDC connection and, in the future, Multi Terminal DC grid. A lot of publications have been published about this topology these ...
    • Multiscale modeling of the anisotropic electrical conductivity of architectured and nanostructured Cu-Nb composite wires and experimental comparison 
      Article dans une revue avec comité de lecture
      GU, TANG; MEDY, J.-R; VOLPI, F; CASTELNAU, Olivier; FOREST, S; HERVE-LUANCO, E.; LECOUTURIER, F; PROUDHON, H; RENAULT, P.-O; THILLY, L (Elsevier, 2017)
      Nanostructured and architectured copper niobium composite wires are excellent candidates for the generation of intense pulsed magnetic fields (> 90T) as they combine both high electrical conductivity and high strength. ...
    • Évaluation de la Performance Technique des Scénarios de Recyclage durant la Conception 
      Communication avec acte
      GRIMAUD, Guilhem; ccPERRY, Nicolas; ccLARATTE, Bertrand (AIP-Priméca, 2017)
      Pour déployer des solutions industrielles de recyclage compétitives pour une large gamme de produits en fin de vie, les recycleurs doivent connaître les performances de chaque solution. Actuellement, les seuls outils ...
    • Comparative analysis of procedures for the estimation of uncertainties in LCA: clay brick case study 
      Article dans une revue avec comité de lecture
      SILVA, Fernanda Belezario; YOSHIDA, Olga Satomi; HORTA ARDUIN, Rachel; VINHAL, Lais D; TEIXEIRA, Claudia Echevenga; OLIVEIRA, Luciana A (2017)
      O presente trabalho tem como objetivo discutir a estimativa de incertezas em ACV, utilizando três procedimentos de cálculo a partir de dados de inventários da produção de blocos cerâmicos de uma fábrica localizada no Estado ...
    • Existence of a Critical Layer Thickness in PS/PMMA Nanolayered Films 
      Article dans une revue avec comité de lecture
      BIRONEAU, Adrien; SALEZ, Thomas; MIQUELARD-GARNIER, Guillaume; SOLLOGOUB, Cyrille (American Chemical Society, 2017)
      An experimental study was carried out to investigate the existence of a critical layer thickness in nanolayer coextrusion, under which no continuous layer is observed. Polymer films containing thousands of layers of ...
    • Successive bifurcations in a fully three-dimensional open cavity flow 
      Article dans une revue avec comité de lecture
      PICELLA, Francesco; LUSSEYRAN, F; CHERUBINI, Stefania; PASTUR, L; ccROBINET, Jean-Christophe; ccLOISEAU, Jean-Christophe (Cambridge University Press (CUP), 2018)
      The transition to unsteadiness of a three-dimensional open cavity flow is investigated using the joint application of direct numerical simulations and fully three-dimensional linear stability analyses, providing a clear ...
    • A bi-harmonic five-phase SPM machine with low ripple torque for marine propulsion 
      article dans une revue avec comité de lecture
      ZAHR, Hussein; ccSEMAIL, Eric; ccSCUILLER, Franck (2017)
      This paper addresses the design of a bi-harmonic five-phase Surface-mounted Permanent Magnet (SPM) machine for marine propulsion. The bi-harmonic characteristic results from the particular 20 slots-8 poles configuration ...