SAM: Recent submissions
Now showing items 3847-3853 of 6547
-
Article dans une revue avec comité de lecture;
BALMES, Etienne; (Elsevier, 2017)
While modal identification is a mature subject, very few studies address the characterization of errors associated with components of a mode shape. This is particularly important in test/analysis correlation procedures, ... -
Article dans une revue avec comité de lecture; ; ; ;MONTAGNE, Alex (Society for Biomaterials and Artificial Organs - India, 2016)
We became interested in this work to study the tribological behavior of two total hip replacements steel AISI 316L and titanium alloy Ti-6Al-7Nb tests performed in this work are essays with reciprocating movement. The ...
-
Article dans une revue avec comité de lecture; ; ;BRAHAM, Chedly (Elsevier, 2017)
The microstructure and the phase identification of austenitic stainless steel AISI 316L with low δ-ferrite content (δ ≤ 1%) and aged for up to 80 000 h at temperatures ranging from 550 to 700 °C were investigated by using ...
-
Article dans une revue avec comité de lecture;SEGONDS, Frederic; ; PERRY, Nicolas (Springer Verlag, 2017)
Additive manufacturing is an innovative manufacturing process that enables rapid manufacturing of functional products and parts. On the other side, considering environmental aspects in design is beneficial as it leads to ...
-
Article dans une revue avec comité de lecture; ; ;SEMAIL, Eric; NGUYEN, Ngac Ky (Institute of Electrical and Electronics Engineers, 2017)
This paper analyzes two fault-tolerant dualmultiphase motor drives, a series connected topology and a standard H-bridge topology. Previous studies have shown that the series connected topology is appropriate to an aerospace ...
-
Article dans une revue avec comité de lecture; ;MARTINS DO OUTEIRO, Jose Carlos; ; ; ; ; ; (Elsevier, 2017)
This paper reviews recent advances in constitutive and friction data and models for simulation of metal machining. Phenomenological and physically-based constitutive models commonly used in machining simulations are presented ...
-
Article dans une revue avec comité de lecture(Elsevier, 2016)The results of the mechanical and tribological characterization of a prototype a-C:Cr, Si sputtered coating are presented. The hardness and the elastic modulus of the coated system have been determined by means of ...
