Thermal analysis in Ti-6Al-4V drilling
TypeArticles dans des revues avec comité de lecture
Ti-6Al-4V is commonly used especially in aerospace and biomedical industries. This alloy is known as a difficult-to-cut material. Due to its poor thermal properties, the heat generated during machining processes traps near material deformation zones. This causes detrimental high temperatures for the cutting tools. This article combines the analytical and FEM modeling techniques to estimate the temperature evolution of carbide tools in Ti-6Al-4V drilling. In this article, a novel thermocouple based temperature measurement setup is also introduced. Moreover, the simulated and measured temperatures under various cutting conditions for the drilling of Ti-6Al-4V are presented for the validation.
Showing items related by title, author, creator and subject.
POULACHON, Gérard; OUTEIRO, José; RAMIREZ, Christophe; ANDRÉ, Victorien; ABRIVARD, Guillaume (Elsevier, 2016)This paper deals with the hole surface quality when CFRP drilling. Mechanical instrumented operations have enabled to follow precisely the damage on the tool margins and the main cutting edges. The amount of uncut fibers ...
RAMIREZ, Christophe; POULACHON, Gérard; ROSSI, Frédéric; M'SAOUBI, Rachid (Elsevier, 2014)The present investigation focuses on the evaluation of tool wear and surface integrity in the context of CFRP cutting. Series of drilling experiments were performed on CFRP plates using cemented carbide solid drills with ...
Understanding the diffusion wear mechanisms of WC-10%Co carbide tools during dry machining of titanium alloys RAMIREZ, Christophe; IDHIL ISMAIL, Andi; GENDARME, Catherine; DEHMAS, Moukrane; AEBY-GAUTIER, Elisabeth; POULACHON, Gérard; ROSSI, Frédéric (Elsevier, 2017)The diffusion wear between a WC-10%Co tool and a Ti54M titanium alloy was investigated by studying the reaction between both the materials using a diffusion couple and studying their behavior during a machining test. In ...
Process Mechanics and Surface Integrity Induced by Dry and Cryogenic Machining of AZ31B-O Magnesium Alloy OUTEIRO, José; ROSSI, Frédéric; FROMENTIN, Guillaume; POULACHON, Gérard; GERMAIN, Guénaël; BATISTA, Antonio (Elsevier, 2013)The corrosion resistance of magnesium alloys depends mainly on its surface integrity. Previous experimental studies have shown that machining can induces small (nano-scale) grain size, compressive residual stresses and ...
BAIZEAU, Thomas; ROSSI, Frédéric; POULACHON, Gérard; OUTEIRO, José (Elsevier, 2016)Surface integrity prediction of hard machining using PCBN cutting tools remains a major topic for many high value added applications. A Flamant–Boussinesq (FB) analytical model has initially been applied for surface integrity ...