Laboratoire Angevin de Mécanique, Procédés et InnovAtion (LAMPA): Soumissions récentes
Voici les éléments 8-14 de 525
-
Communication avec acte;
BEN SAADA, Mariem; LAVISSE, BRUNO; RITOU, Mathieu; GERMAIN, Guenael (Materials Research Forum LLC, 2024-05-15)
The estimation of post-machining distortion of monolithic aeronautical parts induced by the redistribution of the bulk residual stresses (RS) during machining is one of the major challenges of aeronautical parts manufacturing. ... -
Communication avec acte;YESSINE, AYED; LAVISSE, BRUNO; GERMAIN, Guenael (Materials Research Forum LLC, 2024-05-15)
During machining, the friction between the tool and the workpiece (cutting face and flank face) is a significant tribological phenomenon because it strongly influences the cutting operation. Indeed, higher friction leads ...
-
Article dans une revue avec comité de lecture;RITOU, Mathieu; LAVISSE, BRUNO; GERMAIN, Guenael; (Elsevier BV, 2022)
Aluminum alloys are widely used for structural parts in the aerospace industry. Those parts are usually machined from rolled plates or forged blanks, and heat treatments are carried out to reach the necessary mechanical ...
-
Article dans une revue avec comité de lectureLAVISSE, BRUNO; ; BONDARENKO, Dmitry; ; GERMAIN, Guenael (Informa UK Limited, 2023-09-14)
The use of aluminum-lithium alloys in aeronautics is an efficient solution for lightweight structures, but its machinability can cause increased tool wear. The cutting temperature is one of the most important parameters ...
-
Article dans une revue avec comité de lectureKHOCHTALI, Haithem; AYED, Yessine; ; (Springer Science and Business Media LLC, 2021-04-08)
The machining of nickel-based superalloys is often challenging due to their excellent physical properties. High-temperature gradients are generated at the cutting zone, which accelerates the tool wear and impairs its ...
-
Article dans une revue avec comité de lecture;AYED, Yessine; LAVISSE, BRUNO; GERMAIN, Guenael (Elsevier BV, 2024-03-22)
Friction phenomena at the chip/tool/workpiece interfaces during machining of material impacts significantly the cutting process. In this article, the effect of friction conditions (dry, emulsion, cryogenic) on the tribological ...
-
Article dans une revue avec comité de lectureGERMAIN, Guenael; AYED, Yessine; LAVISSE, Bruno; (Springer Science and Business Media LLC, 2023-04-24)
This article discusses the effect of machining assistance on the machinability and surface integrity of titanium and nickel-based alloys for turning operations. The presented results are based on a literature review of the ...
