Improving the PAD actuator performances by vector control
Article dans une revue avec comité de lecture
Auteur
GIRAUD, FrédéricAMBERG, MichelMANGEOT, CharlesLEMAIRE-SEMAIL, BettyRésumé
In this work, we address the problem of pull-out and stalling of the vector control of the piezo-actuator drive (PAD). The model presented reveals the similarities with synchronous machine and therefore we propose the vector control to solve the problem and to enhance its performances. The implementation using a position sensor is tested. Experimental results show that the vector control avoids pull-out and reduces dramatically the voltage applied to achieve the same performances. Speed up to 2.5 times the maximum rated speed at full load could be achieved without loss of synchronization.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Documents liés
Visualiser des documents liés par titre, auteur, créateur et sujet.
-
Communication avec acte; ; ; ;
GIRAUD-AUDINE, Christophe (IEEE, 2015)
This paper presents a method to control ultrasonic waves on a beam, allowing to obtain a Multi-touch ultrasonic tactile stimulation in two points, to give the sensation to two fingers, from two piezoelectric transducers. ... -
Communication avec acte; ; ; ;GIRAUD-AUDINE, Christophe (IEEE, 2017)
The multimodal control of a 2D controlled-Friction Device is presented. We use the Vector control method because the phase and amplitude of two vibration modes at a same frequency can be precisely set. The closed loop ...
-
Article dans une revue avec comité de lecture; ; ; ; ;GIRAUD-AUDINE, Christophe (Elsevier, 2014)
When the frequency of the source of vibration of a piezolectric generator is significantly different from its eigenfrequency, the dielectric power losses become prominent and decrease the amount of power which is practically ...
-
Article dans une revue avec comité de lecture; ; ;GIRAUD-AUDINE, Christophe (Institute of Electrical and Electronics Engineers, 2014)
This paper presents the closed-loop control of exciters to produce a traveling wave in a finite beam. This control is based on a dynamical modeling of the system established in a rotating reference frame. This method allows ...
-
Communication avec acte; ; ; ;GIRAUD-AUDINE, Christophe (IEEE, 2015)
The control of the vibration amplitude, and the resonance frequency tracking for ultrasonic transducer have been established. However, some applications require to control the vibration amplitude and its relative phase at ...