Investigations on Strain Hardening During Cutting of Heat-Resistant Austenitic Stainless Steel
Article dans une revue avec comité de lecture
Date
2020Journal
Journal of Manufacturing Science and EngineeringRésumé
This study presents a novel analysis of the machined subsurface layer formation dealing with strain hardening phenomenon which results from complex mechanisms due to cutting edge multiple passes in drilling. On the one hand, the hardened layer during drilling is characterized in relation with the local cutting geometry and thanks to a quick-stop device (QSD) to suddenly interrupt the operation. Micro hardness is used to determine the hardened thickness of the machined subsurface layers along the local cutting edge geometry. On the other hand, orthogonal cutting performed with a complex self-designed planing experiment is used to investigate in details the hardening accumulation aspects. Then, dedicated methodologies are proposed to quantify the strain hardening as well as the incremental plastic strain generated by consecutive tool passes. In addition to the subsurface hardness evolution, the work material strain is observed during the steady-state cutting process thanks to the high-speed camera. The digital image correlation technique is exploited to analyze not only the plastic strain remaining on the workpiece after the cut but also the effect of the incremental plastic strain generated by the consecutive planing passes as the cutting edges in drilling do. One of the outcomes is that the hardened layer thickness can reach from two to three times the cut thickness in drilling or in planing. As a consequence, this work demonstrates that the cutting process affects itself by hardening. Thus, the studied austenitic stainless steel in such a way that this last is never cut in its initial state.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Documents liés
Visualiser des documents liés par titre, auteur, créateur et sujet.
-
Communication avec acteARIF, Rabiae; MARCON, Bertrand; BLANDENET, Patrick; ROSSI, Frederic; FROMENTIN, Guillaume (Elsevier, 2018)Machining of difficult-to-cut-materials like heat resistant stainless steels leads to the rapid tool wear and tool failure. The analysis of drilling process of these steels is even more difficult as it is not easy to ...
-
Article dans une revue avec comité de lectureIn the present research work, mechanical aspect of transient state in drilling operation is investigated by analyzing together the cutting forces and the chip formation. Particularly, a sudden peak occurring on cutting ...
-
Article dans une revue avec comité de lectureARIF, Rabiae; MARCON, Bertrand; ROSSI, Frederic; FROMENTIN, Guillaume (Society of Manufacturing Engineers, 2020)The aim of the investigations presented in this research work is to optimize the cutting geometry for drilling of Heat Resistant Austenitic Stainless Steel (HRASS) based on the tool life and strain hardening generated on ...
-
Article dans une revue avec comité de lectureIn the thermography process, accurately determining emissivity is crucial to obtain precise temperature measurements as it enables the conversion of radiometric values to absolute temperatures. However, assessing emissivity ...
-
Fast and easy radiometric calibration method integration time insensitive for infrared thermography Article dans une revue avec comité de lecturePOISSENOT-ARRIGONI, Corentin; MARCON, Bertrand; ROSSI, Frédéric; FROMENTIN, Guillaume (Elsevier BV, 2023-06-03)The radiometric calibration of an infrared camera is a crucial and unavoidable step to obtain an accurate tem perature measurement. The calibration does the link between the sensor digital levels and the actual radiometric ...