Laboratoire des Matériaux et Procédés (LaBoMaP): Soumissions récentes
Voici les éléments 183-189 de 382
-
Communication avec acte;
MARTINS DO OUTEIRO, Jose Carlos; ; ; ; ; ; (Elsevier BV, 2019)
This paper deals with the determination of the constitutive model coefficients used in machining simulations. An optimization-based procedure is developed and applied to constitutive model coefficients determination of ... -
Article dans une revue avec comité de lectureBESNARD, Aurélien; ; ; JACQUET, Philippe (Elsevier, 2019)
The Stoney formula, based on the measurement of the substrate curvature, is often used for the determination of the thin films' residual stress. In this study, titanium nitride coatings were deposited by DC reactive magnetron ...
-
Article dans une revue avec comité de lectureRÉGNIER, Tristan; MARCON, Bertrand; MARTINS DO OUTEIRO, Jose Carlos; FROMENTIN, Guillaume; ALAIN, D'acunto; (Taylor & Francis, 2019)
Requirements on burr height and burr amount on machined parts are getting stricter. This leads to method development from manufacturing companies to predict burr distribution and its size along part edges. A deeper ...
-
Article dans une revue avec comité de lecture;ROSSI, FREDERIC; POULACHON, Gerard; ; (Inderscience, 2016)
In aerospace applications, drilling is one of the most common operations. However, this machining stays complex and expensive, especially for difficult-to-cut materials such as titanium alloys. Because drilling is a blind ...
-
Communication avec acte;MARTINS DO OUTEIRO, Jose Carlos; ; POULACHON, Gerard; ; (Elsevier BV, 2019)
Heat exchangers in new nuclear power generation plants are made of thin AISI 316L stainless-steel plates stacked together in order to improve their efficiency and compactness. To ensure the assembly, the global distortion ...
-
Nanocolumnar TiN thin film growth by oblique angle sputter-deposition: Experiments vs. simulations Article dans une revue avec comité de lecture; ;BESNARD, Aurélien; ; ; ; (Elsevier, 2018)
Nanostructured columnar titanium nitride (TiN) thin films were produced by oblique angle deposition using reactive magnetron sputtering. The influence of the angular distribution of the incoming particle flux on the resulting ...
-
Article dans une revue avec comité de lecture;LORONG, Philippe; POT, Guillaume; GIRARDON, Stéphane (Springer Verlag, 2019)
The discrete element method (DEM) is used for continuous material modeling. The method is based on discretizing mass material into small elements, usually spheres, which are linked to their neighbours through bonds. If DEM ...
