Laboratoire des Matériaux et Procédés (LaBoMaP): Soumissions récentes

Voici les éléments 344-350 de 382

    • A force model for superfinish turning of pure copper with rounded edge tools at low feed rate 
      Communication avec acte
      GERMAIN, Dimitri; ccFROMENTIN, Guillaume; ccPOULACHON, Gerard; BISSEY BRETON, Stéphanie (2010)
      This paper presents a model for force prediction of superfinish turning operation on pure copper. The model is divided in two parts. The first part computes the forces acting on the rake face of the tool. The second part ...
    • Mid-infrared absorption properties of green wood 
      Article dans une revue avec comité de lecture
      DUPLEIX, Anna; DE SOUSA MENESES, Domingos; HUGHES, Mark; MARCHAL, Rémy (Springer Verlag, 2013)
      There is a lack of quantitative data on the penetration depth and the amount of energy absorbed by green wood under infrared (IR) radiation. This lack of knowledge is a potential barrier to the development of IR heating ...
    • Measuring the thermal properties of green wood by the transient plane source (TPS) technique 
      Article dans une revue avec comité de lecture
      DUPLEIX, Anna; KUSIAK, Andrzej; HUGHES, Mark; ccROSSI, FREDERIC (De Gruyter, 2013)
      The thermal properties of wood in the green state have been determined by the transient plane source (TPS) technique. Data are presented on thermal conductivity ( λ ), heat capacity ( C ), and thermal diffusivity ( κ ) at ...
    • Investigation of vanadium and nitride alloys thin layers deposited by PVD 
      Communication avec acte
      BRAYEK, A.; TLILI, Brahim; GHRIB, Taher; ccNOUVEAU, Corinne (EDP Sciences, 2012)
      In this work we present the technique of magnetron vapor deposition and the effect of several deposition parameters on the structural and morphological properties of prepared thin films. It was noted that the deposition ...
    • An Experimental and Analytical Method for Investigating Plastic Flow in Form Tapping 
      Article dans une revue avec comité de lecture
      ccFROMENTIN, Guillaume; ccPOULACHON, Gerard; MOISAN, Alphonse (2006)
      While threaded holes made by cutting taps result in material removal, in form tapping, the tap displaces the work material by plastic flow to form the thread section. The aim of the present work is to study, both experimentally ...
    • From large-scale to micro machining: a review of force prediction models 
      Article dans une revue avec comité de lecture
      GERMAIN, Dimitri; ccFROMENTIN, Guillaume; ccPOULACHON, Gerard; BISSEY BRETON, Stéphanie (Society of Manufacturing Engineers, 2013)
      In this paper, a reviewof work performed in the area of force modelling in metal cutting processes is presented. Past and present trends are described and criticised to compare their relevance with current requirements. ...
    • Modeling of interferences during thread milling operation 
      Article dans une revue avec comité de lecture
      ccFROMENTIN, Guillaume; ccPOULACHON, Gerard (Springer Verlag, 2010)
      Thread milling is becoming more and more employed as a technique for producing thread, due to its advantages for industrial manufacturing sectors, such as the aeronautics, aerospace, and energy industries. The thread milling ...