Laboratoire des Matériaux et Procédés (LaBoMaP): Recent submissions
Now showing items 148-154 of 382
-
Article dans une revue avec comité de lecture; ;
JACQUET, Philippe; ; ; NOUVEAU, Corinne (Wiley-VCH Verlag, 2019)
In this article the results concerned influence of processing conditions of the wire electrical discharge machining and vibro‐abrasive machining on the surface layer and morphology of samples made of hard machinable materials ... -
Article dans une revue avec comité de lecture; ;MARTINS DO OUTEIRO, Jose Carlos; ; (American Society of Mechanical Engineers, 2020)
During high-speed machining (HSM), the microstructure of materials evolves with significant plastic deformation process under high strain rate and high temperature, which affects chip formation and material fracture ...
-
Article dans une revue avec comité de lecture; ; ; ; ; ;NOUVEAU, Corinne; MONTAGNE, Alex (Wiley, 2018)
Nanostructured Cr‐Zr‐N thin film with different Zr content (0 to 48.8 at.%) was deposited, using an RF magnetron‐sputtering technique. The structural evolution and morphological changes were performed. The tribological ...
-
Article dans une revue avec comité de lecture;NASSER EDDINE, BELIARDOUH; ; ; ; NOUVEAU, Corinne (2018)
Zirconium nitride (ZrN) thin films were deposited by reactive RF magnetron sputtering on Ti-6Al-4V and Si (100) substrates for potential use in biomedical applications. The tribological behaviour was evaluated against ...
-
Article dans une revue avec comité de lecture; ; ; ;NOUVEAU, Corinne (Elsevier, 2020)
In the present studies, efforts were made to improve corrosion resistance of 90CrMoV8 tool steel by following plasma nitriding. Plasma nitriding of this steel at 500 oC for6and 8 h significantly improved the corrosion ...
-
Article dans une revue avec comité de lecture;VIPREY, Fabien; FROMENTIN, Guillaume; ; DORLIN, Théo (Society of Manufacturing Engineers, 2020)
Machining thin workpieces is a challenging task as geometrical errors may result from the combination of several phenomena. Among these, elastic workpiece deformation and machining induced residual stresses may be predominant ...
-
Article dans une revue avec comité de lecture; ; ; ; ;NOUVEAU, Corinne (Elsevier, 2019)
Vanadium carbide coatings were deposited by R.F. reactive magnetron sputtering at different nitrogen partial pressures. The structures and the mechanical and tribological behaviour of these coatings were studied. By using ...
