Laboratoire des Matériaux et Procédés (LaBoMaP): Soumissions récentes

Voici les éléments 169-175 de 382

    • Thermal treatment effect on structural and mechanical properties of Cr–C coatings 
      Article dans une revue avec comité de lecture
      FELLAH, Mamoun; AISSANI, Linda; ZAIRI, Amel; TOUHAMI, Mohamed Zine; DJEBAILI, Hamid; IOST, Alain; ABDUL SAMAD, Mohammed; ccNOUVEAU, Corinne; ccMONTAGNE, Alex (Maney Publishing, 2018)
      In the present study, the effect of thermal treatment on the mechanical and structural properties of chromium carbide coatings with different thicknesses is evaluated. The coatings were deposited by cathodic magnetron ...
    • Investigation of tool deflection during milling of thread in Cr-Co dental implant 
      Article dans une revue avec comité de lecture
      ARAUJO, Anna Carla; ccFROMENTIN, Guillaume (Springer Verlag, 2018)
      Milling is a good option for manufacturing internal threads in hard-to-cut dental components due to lower cutting forces. In the case of a very small drilled diameter, the tool cannot be large enough to reduce tool deflection ...
    • Kinetic analysis of poplar wood properties by thermal modification in conventional oven 
      Article dans une revue avec comité de lecture
      MARCON, Bertrand; GOLI, Giacomo; MATSUO-UEDA, MIYUKI; UMEMURA, Kenji; GRIL, Joseph; KAWAI, Shuichi; ccDENAUD, Louis (SISEF (Italian Society of Silviculture and Forest Ecology), 2018)
      The kinetics of several poplar (Populus alba L.) wood properties during thermal modification conducted in conventional oven with air recirculation were analysed and modelled in this paper. A wide range of properties was ...
    • Mechanical study in drilling of heat resistant austenitic stainless steel 
      Communication avec acte
      ARIF, Rabiae; ccFROMENTIN, Guillaume; ccROSSI, FREDERIC; MARCON, Bertrand; BLANDENET, Patrick (Elsevier, 2018)
      Machining of difficult-to-cut-materials like heat resistant stainless steels leads to the rapid tool wear and tool failure. The analysis of drilling process of these steels is even more difficult as it is not easy to ...
    • Modeling Thread Milling Forces in Mini-hole in Dental Metallic Materials 
      Communication avec acte
      ARAUJO, Anna Carla; ccFROMENTIN, Guillaume (Elsevier, 2017)
      Abstract Thread milling processes produces lower forces and residual stresses if compared to thread cutting by turning, as the cutting area is lower because the feed rate is not dependent to the cutting speed. In industry, ...
    • Thermomechanical analysis induced by interrupted cutting of Ti6Al4V under several cooling strategies 
      Article dans une revue avec comité de lecture
      LEQUIEN, Pierre; ccPOULACHON, Gerard; ccMARTINS DO OUTEIRO, Jose Carlos (Elsevier, 2018)
      Cryogenic machining has mainly investigated in continuous cutting. Therefore, there is a lack of knowledge on the application of this technology to interrupted cutting, such as in milling. This study aims to investigate ...
    • On the optimization of the cutting conditions for an improved corrosion resistance of OFHC copper 
      Communication avec acte
      DENGUIR, Lamice; ccMARTINS DO OUTEIRO, Jose Carlos; VIGNAL, Vincent; ccFROMENTIN, Guillaume; BESNARD, Rémy (Elsevier, 2018)
      Machining has a particular impact on the surface integrity and on corrosion resistance of components. In fact, material removal induces geometrical, mechanical and micro-structural modifications in the machined surface and ...