Laboratoire des Matériaux et Procédés (LaBoMaP): Recent submissions
Now showing items 211-217 of 382
-
Article dans une revue avec comité de lecture;
DENAUD, Louis; POT, Guillaume; GIRARDON, Stéphane (Springer Nature (since 2011)/EDP Science (until 2010), 2016)
Key messageA modelling method is proposed to highlight the effect of cambial age on the effective modulus of elasticity of laminated veneer lumber (LVL) according to bending direction and veneer thickness. This approach ... -
Communication sans acte; ; ; ; ; ;NOUVEAU, Corinne; MONTAGNE, Alex (2016)
The current research was undertaken to study the improvement of the tribological behavior of nanocrystalline bioceramic, α-alumina sample, produced by the calculations of gibbsite at different temperatures (300 to 1200°C), ...
-
Article dans une revue avec comité de lecture; ; ; ;NOUVEAU, Corinne; MONTAGNE, Alex (Maney Publishing, 2017)
Cr–Zr–N films have been synthesised using R.F reactive magnetron sputtering system on Si (100) wafer and XC100 steel substrate without heating. The structural, mechanical and friction coefficient evolution as a function ...
-
Communication avec acte;POULACHON, Gerard; ROSSI, FREDERIC; AYED, Yessine; (ELSEVIER, 2017)
This work deals with the phenomenon of hole shrinkage during Ti6Al4V drilling. Indeed, the shape and dimensions of the drilled hole, as well as the heat generated by the operation depend on this phenomenon which ...
-
Article dans une revue avec comité de lecture;JACQUET, Philippe; ; FABRE, Agnes; BARRALLIER, Laurent (Springer Verlag, 2014)
The effect of the composition of two steels (B and 6MnCr5) on precipitation of undesirable phases (carbides, nitrides and carbonitrides) under thermochemical treatment (low-pressure or vacuum carbonitriding) is investigated. ...
-
Communication avec acte; ;MARTINS DO OUTEIRO, Jose Carlos; POULACHON, Gerard (ELSEVIER, 2017)
Cryogenic machining is seen as a possible solution to increase tool life and improve surface integrity of machined components, by efficiently removing the heat from the cutting zone. Unfortunately, most of the ...
-
Article dans une revue avec comité de lectureBAIZEAU, Thomas; ; FROMENTIN, Guillaume; (Society for Experimental Mechanics, 2017)
The measurement of machined-part strain fields induced by the cutting process remains a challenge because of the presence of highly intensive and localised strains. In this study, a high-speed double-frame imaging device ...
