Laboratoire d'Etude des Microstructures et de Mécanique des Matériaux (LEM3): Soumissions récentes
Voici les éléments 232-238 de 526
-
Article dans une revue avec comité de lecture
SHIRINBAYAN, Mohammadali; FITOUSSI, Joseph; MERAGHNI, Fodil; ; ; TCHARKHTCHI, Abbas (SAGE Publications, 2017)
This paper presents the experimental results of tension-tension stress-controlled fatigue tests performed on advanced sheet molding compound (A-SMC). It aims at analyzing the effect of fiber orientation, loading amplitude, ... -
Article dans une revue avec comité de lecture(Elsevier, 2019)This article investigates the elastic properties of a large panel of lattice architectures using a continuous description of geometry. The elastic constants of the orthotropic material are determined, and discussed in terms ...
-
Article dans une revue avec comité de lecture(IOP Publishing, 2009)Composite materials based on shape memory alloys (SMA) have received growing attention over these last few years. In this paper, two particular morphologies of composites are studied. The first one is an SMA/elastomer ...
-
Article dans une revue avec comité de lecture; ;MERAGHNI, Fodil; (Elsevier, 2019)
Two analytical approaches are developed to determine the overall size-dependent response of composites embedding general interfaces. The first approach extends the composite sphere assemblage (CSA) approach and the generalized ...
-
Article dans une revue avec comité de lecture; ; ; ;BENAARBIA, Adil (Elsevier, 2019)
In this paper, the low cycle fatigue behaviour of MarBN steels at elevated temperatures is discussed. Four cyclic loading waveforms were applied to investigate both the mechanical and microstructural features. The mechanical ...
-
Article dans une revue avec comité de lectureSHIRINBAYAN, Mohammadali; FITOUSSI, Joseph; MERAGHNI, Fodil; ; ; TCHARKHTCHI, Abbas (Springer Verlag (Germany), 2019)
The purpose of this article is to investigate the effect of an initial pre-damage induced by a fatigue loading on the tensile dynamic behavior of Advanced Sheet Molding Compounds (A-SMC). Tension-tension fatigue preloading ...
-
Article dans une revue avec comité de lecture; ; ;MERAGHNI, Fodil; ; ; (Springer Verlag, 2019)
The consequences of a four-point bending test, up to 12 mm, are examined by emitting 1 MHz ultrasonic guided waves in woven carbon fiber reinforced polymer specimens, using coda wave interferometry (CWI), revealing a ...
