Laboratoire Mechanics, Surfaces and Materials Processing (MSMP): Soumissions récentes
Voici les éléments 162-168 de 422
-
Article dans une revue avec comité de lecture; ;
EL MANSORI, Mohamed; MKADDEM, Ali (Elsevier, 2016)
This work addresses the tribological reliability of TiAlN-based PVD coatings face to TiN-based CVD coating in cutting FRP. Wear and linear pin-on-plate tests were conducted on both glass/epoxy and carbon/epoxy composites ... -
Article dans une revue avec comité de lecture; ; ; ; ;EL MANSORI, Mohamed (Society of Manufacturing Engineers, 2016)
tAA6016-T4 aluminium and DX56D + Z140M steel sheets were joined by fluxless laser weld-brazing pro-cess in industrial conditions and at high brazing speed reaching 6 m/min with ER4043 AlSi5filler wire. Theconfiguration ...
-
Article dans une revue avec comité de lecture; ;EL MANSORI, Mohamed (Society of Manufacturing Engineers, 2017)
There are many 3D printing technologies available, and each technology has its strength and weakness. The 3D printing of sand moulds, by binder jetting technology for rapid casting, plays a vital role in providing a better ...
-
Article dans une revue avec comité de lecture; ;JÉGOU, Sébastien; BARRALLIER, Laurent; (Hanser, 2018)
Nitriding of low-alloy steels is widely used for gears and bear- ings in aerospace industry. Some highly stressed surfaces re- quire high nitrided depth, which involves long time/high tem- perature nitriding treatment. ...
-
Article dans une revue avec comité de lectureDEPRIESTER, Dorian; KUBLER, Regis (Elsevier, 2018)
This paper investigates the relevance of the representation of polycrystalline aggregates using Radical Vorono (RV) tessellation, computed from Random Close Packs (RCP) of spheres with radius distribution following a ...
-
Article dans une revue avec comité de lecture;EL MANSORI, Mohamed; CONIGLIO, Nicolas (Springer Verlag, 2018)
The development of sand mold three-dimensional printing technologies enables the manufacturing of molds without the use of a physical model. However, the effects of the three-dimensional printing process parameters on the ...
-
Article dans une revue avec comité de lecture; ;EL MANSORI, Mohamed; DEMIRCI, Ibrahim (Elsevier, 2013)
Friction reduction, lower oil consumption, and limitation of greenhouse gases emissions are the chief objectives of the automotive industry in order to improve the environmental efficiency of vehicle engines. In this paper, ...
