Cyclic Variation of Residual Stress Induced by Tool Vibration in Machining Operations
Communication avec acte
In machining, due to the tool vibration the forces, temperatures and stresses vary during the cutting process, so as the residual stresses over the machined surface. This variation of the residual stress has never been measured and, therefore, imposes new experimental challenges. The objective of this work is to correlate the variation of the residual stresses along the cutting path with the frequency of the surface geometrical defect generated by the vibration of the tool holding system. In order to perform such correlation a hybrid experimental/analytical approach was applied for an austenitic stainless steel, AISI 316L. Residual stresses were analyzed in the machined specimen along the cutting path using neutron diffraction. The results show a cyclic variation of the residual stresses, which can be detected when considering the frequency of the tool vibration. The frequency of the tool vibration is also correlated with the topology of the surface.
Showing items related by title, author, creator and subject.
Constitutive model incorporating the strain-rate and state of stress effects for machining simulation of titanium alloy Ti6Al4V Communication avec acteCHENG, Wenyu; OUTEIRO, José; COSTES, Jean-Philippe; M’SAOUBI, Rachid; KARAOUNI, Habib; DENGUIR, Lamice; ASTAKHOV, Viktor; AUZENAT, François (Elsevier, 2018)Ti6Al4V titanium alloy is widely used in aero-engines due to its superior performance. However, as a difficult-to-cut alloy, it induces short cutting tool life and poor surface integrity. To improve these process outcomes, ...
Article dans une revue avec comité de lectureCAMPOCASSO, Sébastien; POULACHON, Gérard; BISSEY BRETON, Stéphanie; COSTES, Jean-Philippe; OUTEIRO, José (Elsevier, 2017)Mechanistic cutting force modelling generally involves coefficients identification from machining tests. In order to develop multi-material cutting force models avoiding identification, several studies have tried to link ...
Optimization-based procedure for the determination of the constitutive model coefficients used in machining simulations Communication avec acteCHENG, Wenyu; OUTEIRO, José; COSTES, Jean-Philippe; M’SAOUBI, Rachid; KARAOUNI, Habib; DIETRICH, Stefan; MARCON, Bertrand; ROSA, Pedro (Elsevier BV, 2019)This paper deals with the determination of the constitutive model coefficients used in machining simulations. An optimization-based procedure is developed and applied to constitutive model coefficients determination of ...
Article dans une revue avec comité de lectureCHENG, Wenyu; OUTEIRO, José; COSTES, Jean-Philippe; M'SAOUBI, Rachid; KARAOUNI, Habib; ASTAKHOV, Viktor (Elsevier, 2019)The predictability of manufacturing process simulation is highly dependent on the accuracy of the constitutive model to describe the mechanical behavior of the work material. The model should consider the most relevant ...
Communication avec acteSELMI, Jaouher; COSTES, Jean-Philippe; LORONG, Philippe; POULACHON, Gérard; CARRAS, Patrice (MM Science Journal, 2014)It is proposed to apply a methodology in order to evaluate the ability of different machining systems (Spindle/Tool) to run a reaming process in a stable way.The methodology is based on an experimental measurement of the ...