Evaluation of present numerical models for predicting metal cutting performance ans residual stresses
Article dans une revue avec comité de lecture
JournalMachining Science and Technology
Efforts on numerical modeling and simulation of metal cutting operations continue to increase due to the growing need for predicting the machining performance. A significant number of numer- ical methods, especially the Finite Element (FE) and the Mesh-free methods, are being developed and used to simulate the machining operations. However, the effectiveness of the numerical models to predict the machining performance depends on how accurately these models can represent the actual metal cutting process in terms of the input conditions and the quality and accuracy of the input data used in such models. This article presents results from a recently conducted comprehensive benchmark study, which involved the evaluation of various numerical predictive models for metal cutting. This study had a major objective to evaluate the effectiveness of the current numerical predictive models for machining performance. Five representative work materials were carefully selected for this study from a range of most commonly used work materials, along with a wide range of cutting conditions usually found in the published literature. The differences between the predicted results obtained from the various numerical models using different FE and Mesh-free codes are evaluated and compared with those obtained experimentally.
Files in this item
Showing items related by title, author, creator and subject.
Constitutive model incorporating the strain-rate and state of stress effects for machining simulation of titanium alloy Ti6Al4V Communication avec acteCHENG, Wenyu; OUTEIRO, José; COSTES, Jean-Philippe; M’SAOUBI, Rachid; KARAOUNI, Habib; DENGUIR, Lamice; ASTAKHOV, Viktor; AUZENAT, François (Elsevier, 2018)Ti6Al4V titanium alloy is widely used in aero-engines due to its superior performance. However, as a difficult-to-cut alloy, it induces short cutting tool life and poor surface integrity. To improve these process outcomes, ...
Article dans une revue avec comité de lectureCHENG, Wenyu; OUTEIRO, José; COSTES, Jean-Philippe; M'SAOUBI, Rachid; KARAOUNI, Habib; ASTAKHOV, Viktor (Elsevier, 2019)The predictability of manufacturing process simulation is highly dependent on the accuracy of the constitutive model to describe the mechanical behavior of the work material. The model should consider the most relevant ...
Communication avec acteM'SAOUBI, Rachid; CHANDRASEKARAN, H.; COULON, Bertrand; MARQUES, M.J.; OUTEIRO, José (2008)Machinability enhancement of hot work tool steels can be achieved intrinsically through tailoring of alloying elements and steel processing route but also externally through the use of adequate tooling. The aim of the ...
Article dans une revue avec comité de lectureMELKOTE, Shreyes; GRZESIK, Wit; OUTEIRO, José; RECH, Joël; SCHULZE, Volker; ATTIA, Helmi; ARRAZOLA, Pedro J.; M'SAOUBI, Rachid; SALDANA, Christopher (Elsevier, 2017)This paper reviews recent advances in constitutive and friction data and models for simulation of metal machining. Phenomenological and physically-based constitutive models commonly used in machining simulations are presented ...
Optimization-based procedure for the determination of the constitutive model coefficients used in machining simulations Communication avec acteCHENG, Wenyu; OUTEIRO, José; COSTES, Jean-Philippe; M’SAOUBI, Rachid; KARAOUNI, Habib; DIETRICH, Stefan; MARCON, Bertrand; ROSA, Pedro (Elsevier BV, 2019)This paper deals with the determination of the constitutive model coefficients used in machining simulations. An optimization-based procedure is developed and applied to constitutive model coefficients determination of ...