Numerical and Experimental Approach in Assisted Cryogenic Machining
TypeCommunications avec actes
Understanding of local mechanisms chip forming during machining by removal of material is difficult, to this end; a cutting finite element modelling is required. This study aims initially to model orthogonal cutting of Ti17 titanium alloy in dry and cryogenic machining and in a second time to study the influence of the application of cryogen during machining on temperature fields and cutting forces in numerical simulation. An experimental study was also conducted to determine the mode of tool wear and the evolution of flank wear.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Visualiser des documents liés par titre, auteur, créateur et sujet.
MOREL, Anne; BIGNONNET, André; GERMAIN, Guénaël; MOREL, Franck (Springer, 2010)Fatigue phenomena, which appear generally below the yield stress, is the cause of more than 80 % of in-service mechanical failures. However, the optimization of the weight and cost when designing mechanical components or ...
Identification de lois de comportement représentatives des conditions d’usinage pour des alliages de titane à différentes teneurs alpha/beta GERMAIN, Guénaël; AYED, Yessine; BRAHAM-BOUCHNAK, Tarek; MOREL, Anne (Congrès Français de Mécanique, 2013)Determining a material constitutive law which is representative of the extreme conditions found in the cutting zone during machining operations is a very challenging problem. In this study, dynamic shear tests, which ...
BRAHAM-BOUCHNAK, Tarek; GERMAIN, Guénaël; MOREL, Anne; FURET, Benoit (Taylor & Francis, 2015)The origin of this article is the quantification of productivity gains and the improvement in surface integrity seen for a recent titanium alloy that is seeing increasing use in the aeronautical industry. The Ti555–3 ...
Identification of material constitutive laws representative of machining conditions for two titanium alloys: Ti6Al4V and Ti555-3 GERMAIN, Guénaël; MOREL, Anne; BRAHAM-BOUCHNAK, Tarek (The American Society of Mechanical Engineers, 2013)Determining a material constitutive law that is representative of the extreme conditions found in the cutting zone during machining operations is a very challenging problem. In this study, dynamic shear tests, which ...
BRAHAM-BOUCHNAK, Tarek; GERMAIN, Guénaël; MOREL, Anne; LEBRUN, Jean-Lou (Springer, 2013)The Ti533-3 alloy is a new titanium alloy which is starting to see increased use in the aeronautical domain to improve the durability of components and to optimize the weight/resistance ratio. This alloy is characterized ...