SAM: Soumissions récentes
Voici les éléments 5498-5504 de 6547
-
Article dans une revue avec comité de lecture; ; ; ;
BRAHAM, Chedly (Elsevier, 2013)
The effects of hammering by wire brush as a method of improving low cycle fatigue life of highly ductile austenitic stainless steel AISI 304 have been investigated through an experimental study combining imposed strain ... -
Article dans une revue avec comité de lecture; ; ; ; ; ; ; ; ;BRAHAM, Chedly (Elsevier, 2012)
Multi-reflection grazing incidence geometry, referred to as MGIXD, characterized by a small and constant incidence angle, was applied to measure low surface stresses in very thin layers of Al–Mg alloy and CrN coating. These ...
-
Article dans une revue avec comité de lecture; ; ; ; ;GIRAUD-AUDINE, Christophe (Elsevier, 2014)
When the frequency of the source of vibration of a piezolectric generator is significantly different from its eigenfrequency, the dielectric power losses become prominent and decrease the amount of power which is practically ...
-
Communication avec acte; ;OLABI, Adel; BEAREE, Richard; GIBARU, Olivier (IEEE, 2013)
The use of industrial robots in many fields of industry like prototyping, pre-machining and end milling is limited because of their poor accuracy. Robot joints are mainly responsible for this poor accuracy. The flexibility ...
-
Article dans une revue avec comité de lecture;DUCASSE, Eric (Elsevier, 2014)
This paper describes how a modal approach in the time-domain can be suitable for calculating the elastodynamic field in a layered plate. This elastodynamic field is generated by impulsive sources located in a small region ...
-
Article dans une revue avec comité de lecture; ;BRAHAM, Chedly (Elsevier, 2013)
This paper is aimed at evaluating the residual stress relaxation and its effect on the fatigue strength of AISI 316L steel ground surfaces in comparison to electro-polished surfaces. An experimental evaluation was performed ...
-
Communication avec acte;ALIX, Thecle; PERRY, Nicolas (2014)
Mobile manufacturing is an enabler to increase the possibility to change and to adapt to altering needs, where the geographical position is not fixed. The main idea with the mobile manufacturing concept is to easily and ...
