Creep age forming of Al-Cu-Li alloy: Application to thick sheet forming of double curvature aircraft panel
Conférence invitée
Auteur
YOUNES, WaelGIRAUD, ElianeZOUARI, AhmedDAL SANTO, PhilippeVAN DER VEEN, SjoerdRésumé
Creep-age-forming of a thick Al-Cu-Li sheet is studied. An industrial stamping press is used to form a double curvature panel at a reduced scale. This forming, which includes several relaxation steps, is modelled using ABAQUS. A material model describing an elasto-viscoplastic behaviour with anisotropy effect has been identified and implemented in ABAQUS using Fortran subroutine. The numerical model is validated by comparing experiments and numerical results in terms of deformed shapes and an improved forming cycle is suggested.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Documents liés
Visualiser des documents liés par titre, auteur, créateur et sujet.
-
Conférence invitée(2016)Creep forming of Al-Mg-Li alloy sheets is studied. An instrumented bulging machine is used to form a double curvature panel at a reduced scale. The deformation of the work-sheet is ensured by a 7475 aluminum alloy lost ...
-
Article dans une revue avec comité de lecture;
MAREAU, Charles; AYED, Yessine; ; ; (Elsevier BV, 2020-12-17)
The present work focuses on the simulation of the heat treatment applied after printing of Ti-6Al-4V parts. The numerical tool aims at predicting the influence of heat treatment conditions (e.g. holding time, temperature) ... -
Communication avec acte(Trans Tech Publications, 2015)Anisotropic behavior at high temperature of an Aluminum-Lithium alloy was studied. Mechanical tests at a temperature of 350°C and a strain rate of 10-2 s-1 were carried out on samples taken at different angles with respect ...
-
Article dans une revue avec comité de lecture; ; ; ; ;DANTAN, Jean-Yves (Elsevier, 2013)
Tolerance verification permits to check the product conformity and to verify assumptions made by the designer. For conformity assessment, the uncertainty associated with the values of the measurands must be known. In fact, ...
-
Article dans une revue avec comité de lecture;GERMAIN, Guénaël; ; (Taylor & Francis, 2014)
In this article, the development of an industrial prototype for manufacturing aeronautical fuselage panels is investigated. Deep drawing of large components such as aircraft fuselage panels is not an easy task in terms of ...