Recherche
Voici les éléments 1-10 de 26
Experimental Investigation and Modelling of Burr Formation during Orthogonal Cutting of A356+0.5Cu Aluminium Alloy
Communication avec acte
(2016)
Tribological Behavior of PVD Hard Coated Cutting Tools under Cryogenic Cooling Conditions
Article dans une revue avec comité de lecture
(ELSEVIER, 2017)
Fundamental study of exit burr formation mechanisms during orthogonal cutting of AlSi aluminium alloy
Article dans une revue avec comité de lecture
(Elsevier, 2018)
Etude de la formation des bavures en coupe orthogonale à l’outil carbure dans un alliage d’Aluminium – Silicium.
Communication sans acte
(2016)
Effect of grain direction on cutting forces and chip geometry during green beech wood machining
Article dans une revue avec comité de lecture
(North Carolina State University, 2018)
Phenomenological study of multivariable effects on exit burr criteria during orthogonal cutting of AlSi alloys using principal components analysis
Article dans une revue avec comité de lecture
(American Society of Mechanical Engineers, 2018)
Thermal analysis in Ti-6Al-4V drilling
Article dans une revue avec comité de lecture
(Elsevier, 2017)
Effect of Forestry Management and Veneer Defects Identified by X-ray Analysis on Mechanical Properties of Laminated Veneer Lumber Beams Made of Beech
Article dans une revue avec comité de lecture
(North Carolina State University, 2017)
Phenomenological study of chip flow/formation and unified cutting force modelling during Ti6Al4V alloy turning operations
Article dans une revue avec comité de lecture
(ELSEVIER, 2018)
Mechanical study in drilling of heat resistant austenitic stainless steel
Communication avec acte
(Elsevier, 2018)