Laboratoire des Matériaux et Procédés (LaBoMaP): Soumissions récentes
Voici les éléments 197-203 de 382
-
Article dans une revue avec comité de lecture;
DENAUD, Louis; GIRARDON, Stéphane; VIGUIER, Joffrey (North Carolina State University, 2017)
This study proposes an innovative model based on local grain angle measurements to predict the modulus of elasticity of LVL made from beech. It includes a veneers sorting method industrially compatible thanks to its low ... -
Article dans une revue avec comité de lectureRÉGNIER, Tristan; FROMENTIN, Guillaume; ; MARTINS DO OUTEIRO, Jose Carlos; ALAIN, D'acunto; ; (Elsevier, 2018)
Burr formation during machining is an important issue in industry. It causes an additional deburring operation, which is time consuming and has a negative economic impact. This study aims to analyse burr formation mechanisms ...
-
Article dans une revue avec comité de lecture; ;DENAUD, Louis; POT, Guillaume; VIGUIER, Joffrey (Elsevier, 2018)
This study proposes an innovative model based on local grain angle measurements to predict the modulus of elasticity of LVL made from beech. It includes a veneers sorting method industrially compatible thanks to its low ...
-
Article dans une revue avec comité de lecture;BESNARD, Aurélien; ; ; (Elsevier, 2018)
Molybdenum nitride thin films were deposited on (100) silicon substrates by R.F. magnetron sputtering of a Mo target in a (Ar-N2) gas mixtures. The films were studied by Scanning Electron Microscopy (SEM), Energy Dispersive ...
-
Article dans une revue avec comité de lecture;NASSER EDDINE, BELIARDOUH; ; NOUVEAU, Corinne; BESNARD, Aurélien (IOP Publishing Ltd, 2018)
WCparticles reinforced Fe-based metal matrix composites were synthesized by powder metallurgy process. The microstructure and composition of the specimens were analyzed and the wear-resistant properties againstWCand alumina ...
-
Article dans une revue avec comité de lecture; ;DENAUD, Louis; COLLET, Robert (North Carolina State University, 2018)
Proper valorization of the sawing wastes in industrial sawmills is a permanent issue with strong economic and environmental stakes. Most industrial sawmills are equipped with chipper-canter heads reducing the outer part ...
-
Article dans une revue avec comité de lecture;NOUVEAU, Corinne; ; BESNARD, Aurélien; (Springer Verlag/ASM International, 2018)
The control of residual stresses has been seldom investigated in multilayer coatings dedicated to improvement of wear behavior. Here, we report the preparation and characterization of superposed structures composed of Cr, ...
