Laboratoire des Matériaux et Procédés (LaBoMaP): Soumissions récentes
Voici les éléments 218-224 de 382
-
Article dans une revue avec comité de lecture; ; ; ;
POT, Guillaume; VIGUIER, Joffrey (Springer Verlag, 2017)
This study proposes a model using data from a scanner (X-ray and grain angle measurements) to perform strength grading. The research also includes global measurements of modulus of elasticity (obtained by vibrations and ... -
Article dans une revue avec comité de lecture;POULACHON, Gerard; ; ; ; ROSSI, FREDERIC; MARTINS DO OUTEIRO, Jose Carlos; (Elsevier, 2017)
Ti-6Al-4V is commonly used especially in aerospace and biomedical industries. This alloy is known as a difficult-to-cut material. Due to its poor thermal properties, the heat generated during machining processes traps near ...
-
Article dans une revue avec comité de lecture; ; ; ;NOUVEAU, Corinne (Maney Publishing, 2015)
This work aims to show the characterisation of Cr–V–N coatings, with the varied amounts of Cr and V. CrN, VN and Cr–V–N coatings were deposited onto silicon and XC100 steel substrates by reactive radio frequency magnetron ...
-
Article dans une revue avec comité de lecture; ; ; ; ; ;NOUVEAU, Corinne (Elsevier, 2016)
Zirconium thin films were grown on high carbon steel substrates EN C100 (1 %wt. of carbon) by RF magnetron sputtering. In order to study the reactivity of the film/substrate system as a function of the temperature, one ...
-
A New Methodology for Evaluation of Mechanical Properties of Materials at Very High Rates of Loading Article dans une revue avec comité de lecture;MARTINS DO OUTEIRO, Jose Carlos; ; (ELSEVIER, 2017)
This paper focuses on the development of a straight forward and inexpensive testing machine, and methodology for the characterization of materials in working conditions similar to those found in metal cutting. Special ...
-
Article dans une revue avec comité de lecture;MARTINS DO OUTEIRO, Jose Carlos; FROMENTIN, Guillaume; ; (Elsevier, 2017)
Due to the rising interest in predicting machined surface integrity and sustainability, various models for metal cutting simulation have been developed. However, their accuracy depends deeply on the physical description ...
-
Communication avec acteRÉGNIER, Tristan; FROMENTIN, Guillaume; MARTINS DO OUTEIRO, Jose Carlos; ; ALAIN, D'acunto; (2016)
Burr formation during parts manufacturing is a significant problem that companies try to minimise or eliminate. The present work aims to study the burr formation mechanisms in a cast aluminium alloy. Orthogonal cutting ...
