Laboratoire des Matériaux et Procédés (LaBoMaP): Soumissions récentes
Voici les éléments 232-238 de 382
-
Communication avec acte;
MARTINS DO OUTEIRO, Jose Carlos; FROMENTIN, Guillaume; ; (Elsevier, 2016)
This work aims to develop an orthogonal cutting model for surface integrity prediction, which incorporates a new constitutive model of Oxygen Free High Conductivity (OFHC) copper. It accounts for the effects of the state ... -
Article dans une revue avec comité de lecture;NOUVEAU, Corinne; BESNARD, Aurélien; JACQUET, Philippe; (Lavoisier, 2015)
The objective of this study is to determine the influence of duplex treatment (low pressure thermochemical treatment and PVD coating) on tribological properties. The carbide and carbonitride coatings are deposited by dual ...
-
Article dans une revue avec comité de lecture;BESNARD, Aurélien; FROMENTIN, Guillaume; POULACHON, Gerard; (Inderscience, 2016)
One of the criteria mastering the choice of a cutting tool is its wear resistance. For coated inserts, prior to the coating process, edge preparation method choice will impact their performance. So, a classification based ...
-
Article dans une revue avec comité de lecture;BESNARD, Aurélien; NOUVEAU, Corinne; JACQUET, Philippe (Elsevier, 2016)
The objective of this study is to examine the sudden drop in properties of aluminum, titanium and chromium thin films prepared by the glancing angle deposition method. The thin films were deposited by DC magnetron sputtering ...
-
Article dans une revue avec comité de lectureBAIZEAU, Thomas; ; ROSSI, FREDERIC; POULACHON, Gerard; (Elsevier, 2016)
Conventional piezoelectric sensors cannot record the force fluctuations at high frequencies to monitor serrated chip formation. Recently, force measurements by using digital image correlation (DIC) have been reported thanks ...
-
Article dans une revue avec comité de lecture;FROMENTIN, Guillaume; POULACHON, Gerard; (American Society of Mechanical Engineers, 2016)
Five-axis milling with a ball-end cutter is commonly used to generate a good surface finish on complex parts, such as blades or impellers made of titanium alloy. The five-axis milling cutting process is not straight forward; ...
-
Communication sans acteRÉGNIER, Tristan; FROMENTIN, Guillaume; MARTINS DO OUTEIRO, Jose Carlos; ; ALAIN, D'acunto; (2016)
Le but de cet article est d’étudier l’influence des paramètres de coupe sur la formation des bavures en coupe orthogonale. Pour ce faire, une étude en rabotage est réalisée avec des plaquettes carbures, sur un alliage ...
