Laboratoire des Matériaux et Procédés (LaBoMaP): Soumissions récentes
Voici les éléments 372-378 de 382
-
Communication avec acte; ; ;
FROMENTIN, Guillaume; ; POULACHON, Gerard (2012)
L'obtention des caractéristiques des pièces usinées ainsi que la bonne maîtrise du procédé d'usinage sont liées aux efforts de coupe. De nombreux modèles d'efforts de coupe ont déjà été développés, mais ils sont souvent ... -
Article dans une revue avec comité de lecture; ; ; ;NOUVEAU, Corinne (Wiley-VCH Verlag, 2009)
Recently, several studies have shown that the addition of a secondary element likes Al, Si, etc. to nitride and carbide binary systems such as Ti–N and Cr–N improved their structural and mechanical properties and also their ...
-
Article dans une revue avec comité de lecture(Forest Product Society, 2003)This paper presents a model of load distribution on the cutting edge of a tool during machining Medium Density Fibreboard (MDF). A series of cutting tests has been carried out with tools having designated rake face contact ...
-
Communication avec acte; ;POULACHON, Gerard; (Trans Tech Publications, www.scientific.net, 2011)
In turning, the applied forces have to be known as accurately as possible, especially in the case of difficult-to-cut materials for aircraft workpieces finishing operations. Traditionally, edge discretisation methodology ...
-
Article dans une revue avec comité de lectureFROMENTIN, Guillaume; ; POULACHON, Gerard; ; (American Society of Mechanical Engineers, 2011)
Day by day the application of thread milling process is enhancing in industry because of its inherent advantages over other thread cutting techniques. The current study dwells on the interference issue, which is generated ...
-
Communication avec acte; ; ;FROMENTIN, Guillaume; (Warsaw University of Technology, Faculty of Production Engineering, 2010)
The characterization of friction coefficients at the tool-chip-workpiece interface remains an issue. This paper presents a new experimental set-up able to simulate similar tribological phenomena as the ones occurring at ...
-
Article dans une revue avec comité de lecture; ; ;NOUVEAU, Corinne; COLLET, Robert (Elsevier, 2009)
The aim of this study is first to define the effect of a surface finishing such as sand-blasting on the geometry of a wood cutting tool and its wear resistance. In addition, the effectiveness of surface coatings like CrAlN ...
