Laboratoire des Matériaux et Procédés (LaBoMaP): Recent submissions

Now showing items 281-287 of 382

    • Etude du comportement dynamique de broche d'un centre d'usinage dans son espace de travail : application en fraisage 
      Communication avec acte
      SELMI, Jaouher; COSTES, Jean-Philippe; ccLORONG, Philippe; ccPOULACHON, Gerard; CARRAS, Patrice (2014)
      Une méthodologie est proposée dans cet article dans le but de faciliter l’évaluation de la stabilité d’une opération de fraisage, pour une broche, un outil et une position connue de la broche dans son espace de travail. ...
    • Low friction MoS2TiW Coatings Manufactured on X38CrMoV5-1 Steel Using PVD Method 
      Article dans une revue avec comité de lecture
      ccGOŁĄBCZAK, Marcin; ccJACQUET, Philippe; ccNOUVEAU, Corinne; FLITI, Romain (Wiley-VCH Verlag, 2013)
      In this article the friction coefficients and the wear resistances of MoS2TiW protective coatings manufactured on X38CrMoV5-1 steel samples by using PVD technology are studied. The investi- gations based on tribometer ...
    • An Innovative Experimental Study of Corner Radius Effect on Cutting Forces 
      Article dans une revue avec comité de lecture
      CAMPOCASSO, Sébastien; ccPOULACHON, Gerard; COSTES, Jean-Philippe; BISSEY BRETON, Stéphanie (Elsevier, 2014)
      The cutting forces are often modelled using edge discretisation methodology. In finish turning, due to the smaller corner radii, the use of a local cutting force model identified from orthogonal cutting tests poses a ...
    • Surface profile prediction and analysis applied to turning process 
      Article dans une revue avec comité de lecture
      LU, Chen; COSTES, Jean-Philippe (Inderscience, 2008)
      An approach for the prediction of surface profile in turning process using Radial Basis Function (RBF) neural networks is presented. The input parameters of the RBF networks are cutting speed, depth of cut and feed rate. ...
    • Effect of the sand-blasting of edge peeling tools on the cutting forces and wear resistance 
      Communication avec acte
      LABIDI, Chafik; HENRY, Laurent; ccNOUVEAU, Corinne; ccDENAUD, Louis; ccCOLLET, Robert (Presses Polytechniques et Universitaires Romandes, 2007)
      One of the major problems concerning tools of wood industry is nicks occurrence on the cutting edge. This phenomenon is accentuated by the small tool angle of most of the wood machining tools. The aim of this present study ...
    • Experimental validation of green wood peeling assisted by IR heating – some analytical system design considerations 
      Article dans une revue avec comité de lecture
      DUPLEIX, Anna; ccBATSALE, Jean-Christophe; KUSIAK, Andrzej; HUGHES, Mark; ccDENAUD, Louis (De Gruyter, 2014)
      Experimental results have been used to validate a 2D simulation model in order to check its reliability in predicting the heating of a green log rotating under an IR heating source. For the purpose of validation, it was ...
    • Surface roughness prediction in milling based on tool displacements 
      Article dans une revue avec comité de lecture
      COSTES, Jean-Philippe; MOREAU, Vincent (Society of Manufacturing Engineers, 2011)
      In this paper, an experimental device using non-contact displacement sensors for the investigation of milling tool behaviour is presented. It enables the recording of high frequency tool vibrations during milling operations. ...