Laboratoire des Matériaux et Procédés (LaBoMaP): Recent submissions
Now showing items 274-280 of 382
-
Communication avec acte;
MARTINS DO OUTEIRO, Jose Carlos (Elsevier, 2015)
An experimental-numerical methodology is applied to evaluate the residual stresses induced by drilling of Ti-6Al-4V alloy. The influence of ultra-high cutting speeds on the residual stress distribution is analysed. These ... -
Article dans une revue avec comité de lecture; ; ; ; ;NOUVEAU, Corinne (Elsevier, 2014)
ZnO, Zn0.95Co0.05O and Zn0.90Co0.05M0.05O (M@Al, Cd, Na, Cu) single phase films have been successfully synthesized by ultrasonic spray pyrolysis technique. Structural analysis by X-ray diffraction show that all the films ...
-
Communication avec acte;MARTINS DO OUTEIRO, Jose Carlos; (Elsevier, 2015)
Johnson-Cook constitutive model is still the most used model in metal cutting simulation, although several drawbacks reported in the literature. A high number of Johnson-Cook model parameters can be found in the literature ...
-
Article dans une revue avec comité de lectureNASSER EDDINE, BELIARDOUH; ; ; ; NOUVEAU, Corinne (Elsevier, 2015)
CrN/CrAlN and Cr/CrN/CrAlN multilayers were grown with dual RF magnetron sputtering. The application of these multilayers will be wood machining of green wood. That is why ball-on-disc and electrochemical tests in NaCl ...
-
Article dans une revue avec comité de lectureNASSER EDDINE, BELIARDOUH; NOUVEAU, Corinne; ; JACQUET, Philippe (Elsevier, 2014)
The objective of this work is to study the improvement of the tribological properties of low alloy steel using a duplex treatment of lowpressure carburizing and the deposition of a Cr–(WC–Co) coating by dual RF magnetron ...
-
Communication avec acte; ;DENAUD, Louis; COLLET, Robert; POT, Guillaume (FPInnovations, 2015)
During the primary transformation in wood industry, logs are faced with conical rough milling cutters commonly named slabber or canter heads. Chips produced consist of raw materials for pulp paper and particleboard industries. ...
-
Communication avec acte;MARTINS DO OUTEIRO, Jose Carlos (Elsevier, 2015)
Improving the corrosion resistance of magnesium alloys has gained special focus in recent years, and cryogenic machining has been one of the successfully used techniques. The current study presents a sensitivity analysis ...
