Laboratoire des Matériaux et Procédés (LaBoMaP): Recent submissions
Now showing items 372-378 of 382
-
Communication avec acte; ; ;
FROMENTIN, Guillaume; ; POULACHON, Gerard (2012)
L'obtention des caractéristiques des pièces usinées ainsi que la bonne maîtrise du procédé d'usinage sont liées aux efforts de coupe. De nombreux modèles d'efforts de coupe ont déjà été développés, mais ils sont souvent ... -
Article dans une revue avec comité de lecture(Forest Product Society, 2003)This paper presents a model of load distribution on the cutting edge of a tool during machining Medium Density Fibreboard (MDF). A series of cutting tests has been carried out with tools having designated rake face contact ...
-
Communication avec acte; ;POULACHON, Gerard; (Trans Tech Publications, www.scientific.net, 2011)
In turning, the applied forces have to be known as accurately as possible, especially in the case of difficult-to-cut materials for aircraft workpieces finishing operations. Traditionally, edge discretisation methodology ...
-
Communication avec acte; ; ;FROMENTIN, Guillaume; (Warsaw University of Technology, Faculty of Production Engineering, 2010)
The characterization of friction coefficients at the tool-chip-workpiece interface remains an issue. This paper presents a new experimental set-up able to simulate similar tribological phenomena as the ones occurring at ...
-
Article dans une revue avec comité de lecture;FROMENTIN, Guillaume; POULACHON, Gerard (Elsevier, 2013)
This study deals with the thread milling process that is considered a complex machining technique due to its elaborated tool geometry and its tridimensional tool trajectory. It needed advanced research on the threading ...
-
Article dans une revue avec comité de lecture; ; ; ; ; ; ;NOUVEAU, Corinne (Elsevier, 2006)
This paper presents corrosion behaviour of duplex treated low alloy steel. Different kinds of samples were tested: non-treated, plasma nitrided, ZrBN-triode sputtered and ZrBN-duplex treated samples. The corrosion behaviour ...
-
Article dans une revue avec comité de lecture; ; ;NOUVEAU, Corinne; COLLET, Robert (Elsevier, 2009)
The aim of this study is first to define the effect of a surface finishing such as sand-blasting on the geometry of a wood cutting tool and its wear resistance. In addition, the effectiveness of surface coatings like CrAlN ...
