Elaboration of thin foils in copper and zinc by self-induced ion plating
Article dans une revue avec comité de lecture
Date
2014Journal
MATERIALS SCIENCE (MEDŽIAGOTYRA)Résumé
The aim of this work was to determine the ability to produce thin metallic foils by self-induced ion plating. Foils of pure copper and pure zinc with a thickness of 35 μm have been successfully produced and their characteristics have been compared to foils obtained by conventional techniques (i.e. electroplating and rolling). Results show the following: (i) more or less compact microstructures can be obtained by self-induced ion plating depending on gas pressure and substrate temperature; (ii) microstructures obtained by self-induced ion plating are quite different from those obtained by electroplating and rolling; (iii) Young’s modulus depends on foils roughness; (iv) hardness depends on grain size by exhibiting a Hall-Petch behavior in the case of copper foils and an “inverse” Hall-Petch behavior in the case of zinc foils.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Documents liés
Visualiser des documents liés par titre, auteur, créateur et sujet.
-
Article dans une revue avec comité de lectureCARDON, Amandine; MAREAU, Charles; AYED, Yessine; VAN DER VEEN, Sjoerd; GIRAUD, Eliane; DAL SANTO, Philippe (Elsevier BV, 2020-12-17)The present work focuses on the simulation of the heat treatment applied after printing of Ti-6Al-4V parts. The numerical tool aims at predicting the influence of heat treatment conditions (e.g. holding time, temperature) ...
-
Communication avec acteYOUNES, Wael; GIRAUD, Eliane; DAL SANTO, Philippe (Trans Tech Publications, 2015)Anisotropic behavior at high temperature of an Aluminum-Lithium alloy was studied. Mechanical tests at a temperature of 350°C and a strain rate of 10-2 s-1 were carried out on samples taken at different angles with respect ...
-
Conférence invitéeYOUNES, Wael; GIRAUD, Eliane; ZOUARI, Ahmed; DAL SANTO, Philippe; VAN DER VEEN, Sjoerd (2016)Creep-age-forming of a thick Al-Cu-Li sheet is studied. An industrial stamping press is used to form a double curvature panel at a reduced scale. This forming, which includes several relaxation steps, is modelled using ...
-
Conférence invitéeEL GUEDER, Jawhar; GIRAUD, Eliane; ZHAO, Nan; DAL SANTO, Philippe (2016)Cold stretching of a thin 5154 aluminium sheet is studied. An instrumented bench is developed to analyse the forming of double curvature panels. A numerical tool using ABAQUS software is developed to predict the behaviour ...
-
Conférence invitéeYOUNES, Wael; GIRAUD, Eliane; MONTASSAR, Fredj; DAL SANTO, Philippe; VAN DER VEEN, Sjoerd (2016)Creep forming of Al-Mg-Li alloy sheets is studied. An instrumented bulging machine is used to form a double curvature panel at a reduced scale. The deformation of the work-sheet is ensured by a 7475 aluminum alloy lost ...