Laboratoire des Matériaux et Procédés (LaBoMaP): Soumissions récentes
Voici les éléments 120-126 de 382
-
Article dans une revue avec comité de lecture;
DENAUD, Louis; COLLET, Robert; GIRARDON, Stéphane (MDPI, 2020)
This study presents a method for predicting the local fiber orientation of veneers made from peeled Douglas-fir logs based on the knowledge of the tree branch characteristics (location, radius, insertion angle, azimuth ... -
Article dans une revue avec comité de lecture; ; ;MARTINS DO OUTEIRO, Jose Carlos; (American Society of Mechanical Engineers, 2019)
A great challenge of metal cutting modeling is the ability of the material constitutive model to describe the mechanical behavior of the work material under the deformation conditions that characterizes this process. In ...
-
Communication avec acte; ;NOUVEAU, Corinne; BESNARD, Aurélien; (Springer International Publishing, 2020)
The CrN/CrAlN/Cr2O3 multilayer coatings were deposited by reactive magnetron sputtering DC on 90CrMoV8 stainless steel under various oxygen flow rates. The structure and crystalline phases are characterized by the x-ray ...
-
Article dans une revue avec comité de lecture; ;DENAUD, Louis; COLLET, Robert; GIRARDON, Stéphane (North Carolina State University, 2020)
Log temperature appreciably influences veneer quality during the rotary peeling process. The assessment of the thermal properties of green wood is complex and typically requires the sawing of small calibrated samples. This ...
-
Article dans une revue avec comité de lecture;MARTINS DO OUTEIRO, Jose Carlos; ; ; ; (Elsevier, 2019)
The predictability of manufacturing process simulation is highly dependent on the accuracy of the constitutive model to describe the mechanical behavior of the work material. The model should consider the most relevant ...
-
Article dans une revue avec comité de lecture; ; ;MARTINS DO OUTEIRO, Jose Carlos (Elsevier, 2019)
This work presents the preliminary investigation on the orthogonal machining of Zr-based bulk metallic glass. Influence of machining parameters on the chip formation mechanisms has been analyzed. The SEM images of the chip ...
-
Article dans une revue avec comité de lecture;FROMENTIN, Guillaume; VIPREY, Fabien; ; DORLIN, Théo (Elsevier, 2020)
Machining accuracy can be compromised by elastic workpiece deformation and subsurface residual stress introduction during cutting. In order to anticipate the impact of cutting forces and surface integrity evolutions on ...
